User manual PANASONIC MC-CL675

[. . . ] wARNING: To reduce the risk of fire , electric shock , or injury · This appliance is not intended for use by young children or infirm person without supervision; young children should be supervised to ensure that they do not play with the appliance. Do not use the appliance if the mains lead or plug is damaged or faulty. This appliance is provided with a mains lead and if this becomes damaged, it must be repaired by an Authorized Service Centre or a qualified person in order to avoid any hazard. [. . . ] To secure the main filter rotation, it is advisable to pull out the mains lead pushing down the dust compartment handle. To increase or reduce the power, turn the same button. Manual suction control The curved pipe of the hose is attached with a manual suction control, which allows you to briefly reduce the suction level. Switching between carpet and flooring (Only MC-CL673, MC-CL671) Flooring: Press lever A Carpet: Press lever B Switching 3 positions (Only MC-CL676, MC-CL675) Flooring (PARQUET): Set position A Carpet (short): Set position B Carpet (long or hard to push): Set position C The curved wand of the hose is attached with a manual suction regulator, which allows you to briefly reduce the suction level. After you finish vacuuming, remove the plug from the socket outlet and press the cord rewind button. When rewinding the power cord, press the cord rewind button by holding the plug so that it does not become damaged. NOTE: In case it is impossible to rewind the mains lead, separate dust compartment from the main body, then re-press the cord rewind button. storage position Slide the wand holder attached to nozzle pipe straight into the wand supporter on the under side of the main body. Park position For short breaks during vacuuming, slide the wand holder attached to the nozzle pipe into the wand supporter on the rear side of main body. NOTE: When you use park position, we suggest the appliance is switched off. The plug must be removed from the socket outlet before cleaning or maintaining the appliance. To avoid injury, keep your fingers and hands away from the beater bar. DO NOT use hot air or hot surface to dry filters. Keep at room temperature for approximately 24 hours. IMPORTANT: Before re-installing the washable filters, make sure they are completely dry to avoid damaging the cleaner. D-12 Wipe with a soft cloth soaked with water. Pull up the front of the dust compartment handle and separate dust compartment from main body. If dust remains on the pre-motor filter, wash gently with water and then allow to dry in a shaded location. [. . . ] D-11 After removing the brush cover with a coin, remove the beater bar from the belt. Then cut across threads, strings, hairs, etc. From the beater bar with a pair of scissors. [. . . ]