User manual PANASONIC MC-E3003

[. . . ] Do not pull or carry by the mains lead, use mains lead as a handle, close a door on the mains lead, pull mains lead around sharp edges or corners. do not run vacuum cleaner over the mains lead. Keep the mains lead away from heated surfaces. Do not handle plug or vacuum cleaner with wet hands. [. . . ] The handle may now be lowered almost to the floor as shown. , do not leave the beater bar rotating in the same place for too long. Your Panasonic vacuum cleaner is designed with an Automatic Height Adjustment, which adjusts the cleaning head to the proper height of any carpet pile. This system allows you to move from one carpeted area to another, without having to make time consuming manual adjustments. 1) To use the accessories keep the vacuum cleaner in upright position. 2) Pull out the hose from the rear side of the vacuum cleaner and remove the hose from the hose clip and support. Then connect any accessory as illustrated. NOTE: When finish using the accessories, re-insert the hose to the suction inlet and re-install the hose into the hose clip and support. While using the accessories, hold the handle with one hand to avoid pulling the cleaner over. to prevent damage to carpeted floors , Linoleum , etc. , tilt the cleaner back so that the cleaning head is raised off the floor. To avoid accidental injury, keep children away from the beater bar while in operation. The dust bag check indicator (orange mark) will appear in the window, when airflow through the dust bag is insufficient. When this happens, check the dust bag, it may be full or blocked with fine dust and needs to be replaced. NOTE: If after replacing the dust bag, the yellow mark continues appearing in the window, check to see if the hose or suction inlet is clogged. Also the yellow mark can appear when using the crevice nozzle. IMPORTANT NOTE:Before servicing any part, always DISCONNECT THE CLEANER FROM THE MAINS SUPPLY WICHTIGER HINWEIS:Vor der Wartung irgendwelcher Teile TRENNEN SIE DEN STAUBSAUGER IMMER VOM STROMNETZ AB 4) Press bottom of the dust bag and set it completely inside the dust bag compartment. Make sure all edges of the dust bag are completely inside the bag compartment. IMPORTANT: Dust bag should be changed regularly for the maximum efficiency of the filters and prolonged motor efficiency. Never use the cleaner without the dust bag. [. . . ] Thermal Cut-out This vacuum cleaner is fitted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of the motor. When this happens, disconnect the cleaner from the mains socket and check the dust bag as it may be full or clogged with fine dust. After replacing the dust bag or removing the obstruction, leave the vacuum cleaner to cool down until the thermal cut-out resets after approximately 40 minutes. Important: The thermal cut-out will not reset if the unit is not disconnected from the mains socket. [. . . ]