User manual PANASONIC MC-E583

[. . . ] ⷠDo not use the appliance if the mains lead or plug is damaged or faulty. ⷠThis appliance is provided with a mains lead and if this becomes damaged, it must be repaired by an Authorized Service Centre or a qualified person in order to avoid any hazard. ⷠUnplug from the socket outlet when not in use and before cleaning the appliance or undertaking maintenance operations · Turn off the appliance before removing the plug. Do not pull on the mains lead, always pull on the plug body itself · Do not handle plug or vacuum cleaner with wet hands. [. . . ] After removing the obstruction, leave the cleaner to cool down until the thermal cut-out resets after approximately 60 minutes. C-1 Pull out the mains lead and put the plug into the socket outlet. oN/OFF switch button (P) To start or stop the cleaner , press the button. Switch knob button (N) To increase or reduce the power, turn the button. (Only MC-CL483K, MC-E583) C-3 Switching between carpet or flooring Flooring : Press lever A Carpet : Press lever B (Only MC-CL481K, MC-CL483K) Switching 3 positions for MC-E583 Flooring (PARQUET): Set position A Carpet (short) : Set position B Carpet (long or hard to push): Set position C The curved wand is attached with manual suction regulator, which allow you to briefly reduce the suction power. Cord rewind button (O) After you finish vacuuming, remove the plug from the wall socket and press the button to rewind back the mains lead. When rewinding the mains lead, always hold the plug so that it does not become damaged or stricking you. NOTE: In case it is impossible to rewind the mains lead, pull out the mains lead and press the button again. storage position Insert the nozzle holder straight in the nozzle supporter on the under side of the main body. Park position For short breaks during vacuuming, insert the nozzle holder straight to the nozzle supporter on the rear side of the main body. NOTE: When you use park position, please turn off the power first to prevent from heating up. If after having checked the mentioned points, the cleaner does not work, take it to an Authorized Service Centre to be repaired. D - 15 Wash gently with water and then allow to dry in a shaded location. Do not wash the filter in a washing machine or dry it with a dryer or other source of hot air. How to empty the dust compartment IMPORTANT: Empty the dust compartment when it is full or the suction power seems to be bad. Check whether the wands, hose and accessories are blocked or not. If it is blocked with dust, clean it first. Remove the dust accumulated in the filter unit by tapping it against a hard surface lightly. NOTE: Don't clean the filter unit by brush or clean it with water. Floor nozzle D - 10 Inspect once a month. Using an old toothbrush or similar tool, clean any dirt or lint from the brush. Turbine nozzle D - 11 After removing the brush cover with a coin, remove the beater bar from the belt. [. . . ] Note: Specifications are subject to change without notice. Order accessory and consumable items for your product with ease and confidence by phoning our Customer Care Centre Mon - Thu 9:00am - 5. Or go on line through our Internet Accessory ordering application at www. Most major credit and debit cards accepted. [. . . ]