User manual PANASONIC MC-E7113

[. . . ] If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. [. . . ] Switching between carpet and flooring Flooring: Press lever A Carpet: Press lever B The curved wand of the hose is attached with a manual suction control, which allows you to briefly reduce the suction level. After you finish vacuuming, remove the plug from the socket outlet and press the cord rewind pedal. When rewinding the mains lead, press the cord rewind pedal by holding the plug so that it does not become damaged. Storage position Insert the wand holder straight into the wand supporter. NOTE: When storing the vacuum cleaner upright, be careful of plug and cleaning tools not to scratch the floor surface. Park system For short breaks during vacuuming, slide the hook attached to the nozzle pipe into the slot on the rear side of the cleaner. NOTE: When you use park position, we suggest the appliance is switched off. C-2 C-3 C-4 C-5 C-6 B - HOW TO ASSEMBLE YOUR CLEANER B-1 Insert connection pipe into the suction inlet until it locks. When removing hose assembly, pull out connection pipe with pushing down two connection buttons. NOTE: Do not bend, pull and step on the hose or put anything heavy on it. Connect the two extension wands by inserting one into the other and twisting together. Insert the hose unit into the upper end of the connected extension wand, and the floor nozzle to the other end. C-7 B-2 B-3 4 D - MAINTENANCE AND SERVICING CAUTIONS · The plug must be removed from the socket outlet before cleaning or maintaining the appliance. · DO NOT use hot air or hot surface to dry filters. Keep at room temperature for approximately 24 hours. · IMPORTANT: Before re-installing the washable filters, make sure they are completely dry to avoid damaging the cleaner. Indicator for replacing the dust bag Lift the nozzle off the floor. If the dust indicator turns red, the dust bag is full and requires replacing the dust bag. NOTE: If the dust bag is not properly installed, the cover will not fully close. Be sure to check that the bag is properly installed before operating, otherwise dust will leak out. [. . . ] If the secondary filter is not installed, it will cause motor failure. · Do not wash the secondary filter in a washing machine or dry it with a dryer or other source of hot air. REMINDER FOR CUSTOMER The model and serial number of this product may be found on the nameplate located at the underside of your cleaner. You should note the model and serial number in the spaces provided and retain this book as a permanent record of your purchase. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]