User manual PANASONIC NCJD40C

[. . . ] For repairs (other than replacing consumable parts), please contact our Service Center. Do not put ice into the container and try to use it keep water Flow control 3. 0 cool. Dispensing spout 2. 0 1. 0 pad Condensation may occur, and later you may receive an electrical shock or the unit may malfunction. Main unit Power Cord To Prevent Burns Do not allow children to use the unit and do not leave the unit within the reach of infants. They may be seriously burned, or receive an electrical shock and they can die from their injuries. Do not fill with water beyond the full pot mark. Hot water can spill causing burns. Do not boil anything other than water. If tea bags, tea leaves, milk or alcohol are put in the container, they may cause it to spurt hot liquid or steam and you may be seriously burned. Those items may also cause the water tube to become clogged. The container may burn or corrode, and the fluororesin insulating coating may peel off. Do not tilt or knock over the main unit. Even when the flow control pad is locked, if the main unit is knocked over, hot water may flow from the dispensing spout or the steam vent. You may be seriously burned. Do not lift, tilt or shake the unit. Do not move the unit by the lid. Even when the flow control pad is locked, if the main unit is tilted, hot water may flow from the dispensing spout or the steam vent. [. . . ] (The water may overflow, get into the electric parts, and cause trouble. ) Fill in water to a position from the "Refill" mark to the "Top level" mark. (When there is too little water, the function for prevention of empty heating will operate, and when there is too much water, hot water may spill from the spout. ) Refill mark Top level mark Note: When water is heated in a kettle and filled into the jar pot, the function for prevention of empty heating may operate. 2. The unlock lamp will go out. Lock Note: For some time after boiling, bubbles from the boiling may get into the pump and dispensing may be impaired. This can be corrected by opening and closing the lid. * Watch out for the steam when opening the lid. Refill when the water level has dropped. Refill before the "Refill" position is reached. Caution: Do not leave the jar pot standing with an open lid. (This may cause the function for prevention of empty heating to operate. ) "Refill" position Empty the jar pot when it is not being used. Caution: Do not discharge hot water from the operation side. (This can cause trouble. ) Do not leave water in the inner container. (This can cause rust and/or smell. ) Note: When there is still a remaining charge after the plug has been pulled, the temperature indication will appear. 18 Lock Unlock Lock Unlock Flow Control Flow Control Flow Control Flow Control Lock Unlock Lock Unlock 19 Convenient use methods To save electricity Electricity can be saved by lowering the holding temperature from about 98C to about 85C or about 60C. Use the timer when the jar pot is not to be used for some time, for example at night. Setting is possible in steps of 4, 6, 8, and 10 hours. Further savings are possible by combining the timer and a holding temperature of 85C or 60C. 85C 60C Holding temperature 85C Press Select Holding temperature 60C . Press Select Dechlorination Long Boil Cleaning Temp. 60 85 Dechlorination Long Boil Cleaning Temp. 60 85 and set to and set to . h h 98 98 Keep Warm Keep Warm In about 1. 5 hours, the water temperature will drop to about 85C (in case of filling up to the top level and a room temperature In about 6 hours, the water temperature will drop to about 60C (in case of filling up to the top level and a room temperature of 20C). Dechlorination Long Boil Cleaning Temp. 60 85 98 Dechlorination Long Boil Cleaning Temp. of 20C). The temperature indication drops as shown below: The temperature indication drops as shown below: Tip: 60 85 98 A water temperature of about 85C is also appropriate for green tea. Holding at 85C also can be set during heating. Tip: A water temperature of about 60C is also appropriate for baby milk. Holding at 60C also can be set during heating. Keep Warm Keep Warm Dechlorination Long Boil Cleaning Temp. 60 85 Setting the timer Example: Setting for 8 hours at 10 o'clock in the evening h Press Timer and display . 10 o'clock in the evening: Timer start 98 The remaining time is indicated in units of 1 hour. The temperature will drop, but a minimum temperature of about 60C will be maintained. Dechlorination Long Boil Cleaning Temp. 60 85 6 o'clock next morning: Timer end The water temperature will start to rise and holding will be done at the set temperature. h Tip: The timer also can be set during heating. In this case, the water first will be heated until it boils. 98 20 Select Select Select Select Timer Timer 21 Convenient use methods When hot water is desired during holding or during timer operation For coffee, tea, instant food, etc. MADE IN JAPAN The mark moves each time the button is pressed, so that the setting for the holding temperature can be changed. Reboil Timer Dechlorination Long Boil Cleaning Temp. h Cleaning The setting time for the timer changes each time the button is pressed. Cancel 60 85 98 Select Keep Warm (Return to temperature indication) During holding and use of the timer When the water temperature has dropped because of refilling etc. , the water will be heated once until it boils. The water in the inner container is circulated once about every 6 hours. This is done to prevent accumulation of bubbles in the pump, which can impair dispensing. Lit Dechlorination Long Boil Cleaning Temp. h Reheating Press Reboil . Boiling will be notified after several minutes. 60 85 98 Buzzer sound Time until boiling Holding at 98C: About 3 or 4 minutes Holding at 85C: About 8 to 10 minutes During timer operation: Within 18 minutes (Filled up to the top level and at a room temperature of 20C). Tip: Goes out Dechlorination Long Boil Cleaning Temp. h The holding temperature and the timer setting remain as they are. Lit 60 85 98 22 Cleaning Cleaning Cancel Cancel Reboil Reboil 3 8 4 10 18 3 8 4 10 18 23 Maintenance (always first discharge the water and wait for the unit to cool down) Daily maintenance Main unit and lid Wipe any water off the main unit and the lid using a dry dish cloth. Caution: Do not submerge the main unit or the lid in water. (If water enters the main unit from the bottom or from the dispensing spout, it can also get into the electrical components in the main unit and it may cause a malfunction. ) Do not use detergents. [. . . ] Since fluorine insulation is applied all the way down to or near the bottom of the container, the surface may be gritty and the color can be different from that on the side. 31 Replacement of parts Charcoal filter Replace after 6 months (to maintain the purification effect) Filter If the filter has been washed with a brush but scale cannot be removed, replace it. The filter can be removed by pulling firmly on it. (It is secured in place with a magnet. ) Rubber seal If the seal has lost its flexibility or if steam is leaking from a space between the lid and the pot due to cracks in the seal, replace it. Sealing packing A Set the packing groove onto the lid cover. Seal packing B 1 Install with the packing holes matched to the screw holes of the lid. 2 Place the lid cover on top and tighten it with the screws. 1 1 2 2 Consumable parts are available from an authorized dealer. Part name Rubber packing set Filter Part No. [. . . ]