User manual PANASONIC NE-2153EUG

[. . . ] Ammattikäyttöön (Alkuperäisten ohjeiden käännös) (Oversettelse av de originale instruksjonene) (Oversættelse af originale instruktioner) (Översättning av originalinstruktionerna) (Traduzione delle istruzioni originali) (Traducción de las instrucciones originales) (Vertaling van de oorspronkelijke instructies) (Traduction des instructions d’origine) (Übersetzung der ursprünglichen Anweisungen) (Original instructions) Deutsch Français Nederlands Español Italiano NE-2153-2/NE-1653 NE-2143-2/NE-1843/NE-1643 NE-2153-2/NE-1653 NE-2143-2/NE-1843/NE-1643 Svenska Dansk Please read these instructions completely before operating this oven and keep for future reference. Memory Pad Heating for Double/Triple Quantity Heating. 282 This product is an equipment that fulfills the European standard for EMC disturbances (EMC = Electromagnetic Compatibility) EN 55011. According to this standard this product is an equipment of group 2, class B and is within required limits. [. . . ]  Make sure the oven is plugged into a properly earthed electrical outlet. €PROG” sign will start to blink in the Digital Display Window. The pad number and the previously programmed information will appear in the Digital Display Window. The selected power level will be displayed in the window and the single stage heating indicator “1” will start to blink.  Set the desired heating time by touching the appropriate Number Pad. Note:  he maximum set time for “DEFROST” and “P0” is 30 minutes, and T 15 minutes for all others. The “PROG” sign and the single stage heating indicator “1” will stop blinking. This means that you have completed programming the selected Memory Pad for the single stage heating. W Note:   hen the “PROG” Display is blinking, the program can be cancelled and/or one touch on Stop/Reset Pad erased the programmed Number/Memory Pad number. ς hen you want to program B or C side, touch Shift (A/B/C) Pad before touching W Program Number Pad.  Select Power Level for the second stage by touching Power Level Selector Pad. The selected Power Level will be displayed in the window and the second stage heating indicator “2” will start to blink.  Set the desired heating time by touching appropriate Number Pads. Note:  he maximum set time for “DEFROST” and “P0” is 30 minutes, and T 15 minutes for all others. However, the TOTAL TIME can be set up to 25 minutes, and 15 minutes for continuous heating (1 to 5 stage heating) that excludes “DEFROST” and “P0”.  Touch Prog Pad again and the “PROG” sign and the second stage heating indicator “2” will stop blinking. The total time for both stages will be displayed. This means that you have completed programming the desired Memory Pad for the second stage heating.  Program the remaining pads as desired by repeating the Steps above. W Note:   hen you want to program B or C side, touch Shift (A/B/C) Pad before touching Program Number Pad. ς epeat the above procedure to set Heating for the third stage and later stages.  Make sure the oven is plugged into a properly earthed electrical outlet. [. . . ] PROBLEM Temperature of exhaust air too High Defective Thermistor Circuit Defective Control Panel Defective Relay Circuit Defective Relay Circuit Memory cooking has exceeded the maximum time during double quantity and triple quantity setting. Disconnect the power cord from the wall socket. Note: Above Codes shown in the display do not indicate all the possible failures on the unit. installation Instructions for Stacking Important 1. [. . . ]