User manual PANASONIC NN-GD469MEPG

[. . . ] To find the location of the studs, one of the following methods may be used: A. Use a stud finder, a magnetic device which locates the nails in the stud. Use a hammer to tap lightly across the mounting surface to find a solid sound. The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. [. . . ] Open the bottom of the carton, bend the carton flaps back and tilt the oven over to rest on plastic foam pad. Lift carton off oven and remove all packing materials, Installation Instructions, Wall Template, Top Template, Charcoal Filter, Turntable and Turntable Support; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the ceiling in the oven cavity. SAVE THE CARTON AS IT MAY MAKE INSTALLATION EASIER. Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact your dealer or PANASONIC AUTHORIZED SERVICER. Remove and save Screw (A) as shown in Figure 6. If your oven comes with the louver installed, push down carefully on the tabs (B) and (C) at the ends of the louver to disengage it. Pull the louver away from the unit and set aside. Loosen the two Mounting Screws (D) which secure the Mounting Plate to the rear side of the oven. See Figure 7. Mounting Plate (A) (B) (C) Mounting Plate (D) (D) Control Panel Side Figure 6 Figure 7 8 VENTILATION SYSTEM This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 9 on page 5. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. CAUTION: Do not pull or stretch hood fan wiring. Rotate the Hood Fan Unit 90 degrees so that the fan blade openings are facing upward. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan Cover Bracket. Make sure the fan blades are visible through the top openings in the oven before proceeding. Attach the Fan Cover Bracket to unit with 3 screws, which were removed in Step 1 above. The Hood Fan Unit is now rotated for vertical exhaust operation. Attach the Exhaust Damper Assembly 8 to the fan cover on the top of the outercase cabinet after mounting the oven. To attach the Exhaust Damper Assembly, refer to MOUNTING OVEN TO THE WALL, Step 7 on page 7. Figure 14 9 OVEN INSTALLATION THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES. [. . . ] Hook the three lower tabs of Louver E into the slits of the oven faceplate. Then insert three upper tabs of Louver E into the slits of the oven faceplate. NOTE: The upper middle tab should be inserted between the oven faceplate and the outercase cabinet. Figure 18 Louver (cross section) Upper Tabs Or Louver F (some models) 4. Insert the top tabs of hood Louver F into the 3 openings on the cavity faceplate holding Louver F at a slightly outward tilt. [. . . ]