User manual PANASONIC NP-B6M1FI

[. . . ] symbol Meaning Volts Direct current V I. ADDITIONAL SAFETY RULES n0 … min-1 Ah No load speed Revolutions or reciprocations per minutes Electrical capacity of battery pack Read the operating instructions before use. 1) Wear ear protectors when using the tool for extended periods. 2) Be aware that this tool is always in an operating condition, since it does not have to be plugged into an electrical outlet. [. . . ] battery level indication is just guide. The indication may change due to the condition of battery or ambient temperature. Recommended Grip Use the grip to hold and operate the driver with one hand. If the job requires additional force, you can push against the rear end of the driver with your other hand. Indb 8 2013-8-8 16:29:29 [Battery Pack] For Appropriate Use of Bat­ ery Pack t Li-ion Battery Pack • For optimum battery life, store the Li-ion battery pack following use without charging it. € When charging the battery pack, confirm that the terminals on the battery charger are free of foreign substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. € When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns or a fire. € When operating the battery pack, make sure the work place is well ventilated. (There should be no more than a 15°C difference between the temperatures of the battery and the charging location. Be sure to charge the battery before use. The battery pack is being charged slowly to reduce the load on the battery. Charging will begin when temperature of battery pack drops. If the temperature of the battery pack is -10° or less, the charging status lamp (orange) will also start flashing . Charging will begin when the temperature of the battery pack goes up" Charging is not possible. Clogged with dust or malfunction of the battery pack. Turn off Illuminated Flashing Information for Users on Collection and Disposal of Old Equip­ ment and used Batteries These symbols on the products, packaging, and/or accompanying docu­ ents mean m that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used bat­eries, t please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inap­ ropriate waste handling. P For more information about collection and recycling of old products and bat­eries, t please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. [. . . ] If a new plug is to be fitted please observe the wiring code as shown below. IMPORTANT: As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. [. . . ]