User manual PANASONIC NV-DS35EG

[. . . ] Before use, please read these instructions completely. As this equipment gets hot during use, operate it in a well-ventilated place; do not install this equipment in a confined space such as a bookcase or similar unit. Carefully read the Operating Instructions and use the Movie Camera correctly. Injury or material damage resulting from any kind of use that is not in accordance with the operating procedures explained in these Operating Instructions are the sole responsibility of the user. [. . . ] It is not possible to add a Wipe or Mix effect during playback of an unrecorded part on the tape. If you press the [OFF/ON] Button while the Wipe or Mix is being performed, the effect is paused at that point. If you press the [OFF/ON] Button again, the effect resumes. (Playback Zoom) With this function, you can enlarge a part of the picture by up to 10 times during playback. Slide the [OFF/ON/MODE] Switch from the [ON] position to put the Movie Camera in the VCR Mode. The center part of the picture is enlarged about 2 times. While pressing the [SHIFT] Button on the Remote Controller, press the Arrow Buttons (, , , ) for the direction in which you want to shift the enlarged part of the picture. When you stop playback, the position of the part of the picture to be enlarged is automatically reset to the center. In the Playback Zoom Mode, it is not possible to adjust the sound volume. Turning the Movie Camera off or switching it from the VCR Mode over to the Camera Mode automatically cancels the Playback Zoom Mode. Even while you are using the Playback Zoom Function, the picture output from the DV Terminal (l 8) and the Digital Still Picture Terminal (l 78) is not enlarged. The more the picture is enlarged, the more its picture quality deteriorates. if you press the [MULTI] Button in the Playback Zoom Mode , the zoom magnification becomes 1t. It is not possible to use the Mirror Mode of the Digital Effects and the Playback Zoom Function at the same time. You can add music or narration on a recorded cassette. If you perform audio dubbing onto a tape that was recorded with [AUDIO REC] on the [OTHER FUNCTIONS] Sub-Menu of the [CAMERA FUNCTIONS] Main-Menu set to [16bit], the original sound is erased. (If you intend to perform audio dubbing but also want to keep the original sound, be sure to set [AUDIO REC] to [12bit] before making the original recording. ) It is not possible to perform audio dubbing onto recordings made in the LP Mode. Insert the recorded cassette and slide the [OFF/ON/MODE] Switch from the [ON] position to put the Movie Camera in the VCR Mode. At the point from which you want to insert the new sound, switch the Movie Camera over to the Still Playback Mode. Using Cue Playback, Review Playback or Variable Speed Playback makes it easy to search for this point. Depending on the setting selected for [12bit AUDIO] on the [OTHER FUNCTIONS] Sub-Menu of the [VCR FUNCTIONS] Main-Menu, the sound added with audio dubbing and the original sound are played back as follows: ST1: The original sound alone is played back. [. . . ] If the video heads are dirty, the picture cannot be played back clearly. P1: S1: No sound is played back from the Movie Camera's built-in speaker. During playback, keep the [PUSH] Dial pressed until the [VOLUME] Indication appears. then turn the [PUSH] Dial to adjust the volume. [. . . ]