User manual PANASONIC NV-DS65B

[. . . ] Digital Video Camera Operating Instructions NV-DS60B NV-DS65B Model No. NV-DS60 NV-DS65 Before use, please read these instructions completely. Web Site: http://www. panasonic. co. uk/index. html LSQT0681B Before Use Dear Customer, We would like to take this opportunity to thank you for purchasing this Panasonic Movie Camera. Please read these Operating Instructions carefully and keep them handy for future reference. Please note that the actual controls and components, menu items, etc. of your Movie Camera may look somewhat different from those shown in the illustrations in these Operating Instructions. Information for Your Safety As this equipment gets hot during use, operate it in well ventilated place; do not install this equipment in a confined space such as a bookcase or similar unit. [. . . ] (l 29) AWB: Automatic White Balance Mode (l 27) 1: White Balance setting Mode (l 27) z: Outdoor Mode (l 27) {: Indoor Mode (recording under incandescent lamp) (l 27) Z. MIC: Zoom Microphone (l 23) WIND CUT: Wind Noise Reduction (l 26) æ: Progressive Photoshot Mode (l 22) : Video Light is on. (l 21) VOLUME: Volume adjustment (l 32) 15:30:45: Date/Time Indication (l 47) PLEASE WAIT: While Card is being read (during Playback, Formatting and MultiPicture Function use) (l 40) PROCESSING: Card Photoshot Recording (l 41) COMPLETED: Card Photoshot Recording completed (l 41) CONNECT WITH PC: Movie Camera is connected with PC. 4: 46 PC connection mode (in Camera mode or VCR mode) STORAGE: PC connection mode (in Card playback mode) 00: Remaining Number of Card Photoshot pictures (l 41) 100-0001: DCF Number (l 42) D-001: Number of prints set by DPOF (l 45) 1(white): File Number ([640k480] Image size) (l 42) 1(green): File Number ([320k240] Image size) (l 42) ¥: DPOF Setting completed (l 45) 640: [640k480] Image size For images not recorded with this Movie Camera, the size display is determined as follows according to the number of horizontal pixels. 320: [320k240] Image size 640: From 640 to 800 (The size is not displayed at under 640 pixels. ) SVGA: From 800 to 1024 XGA: From 1024 to 1280 SXGA: From 1280 to 1600 UXGA: Over 1600 WEBCAM: Warning/Alarm Indications If any one of the following indications lights up or flashes, please check the condition of the Movie Camera. Some Indications may not be displayed according to the model. (l 54) Y: The accidental erasure prevention slider on the inserted Cassette is open (that is, set to [SAVE]). You are about to do audio dubbing on the unrecorded (blank) portion of the tape. (l 12) 0: The button-type battery is discharged. (l 55) 2END: The tape came to end during recording. REMOTE: Wrong Remote Controller Mode has been selected. (l 48) UNPLAYABLE TAPE (OTHER FORMAT): You are attempting to play back a tape section that has been recorded with a different TV system. DUB (LP RECORDED): Because the original recording was done in LP Mode, audio dubbing cannot be performed. INCOMPATIBLE TAPE: This Cassette is incompatible. CARD LOCKED: When you are attempting to write the data on an SD Memory Card whose write protection switch is set at [LOCK]. FILE LOCKED: When you are attempting to delete a locked picture. NO SPACE LEFT: Card does not have sufficient memory remaining. CARD FULL: Card does not have sufficient memory remaining. NO PICTURE: Card has no pictures recorded on it. ª To Change the Counter Display Mode By changing [C. DISPLAY] on the [DISPLAY SETUP] Sub-Menu, you can change the Counter Display Mode to Tape Counter Indication [COUNTER] (0:00. 00), Memory Counter Indication [MEMORY] (M0:00. 00), and Time Code Indication [TIMECODE] (0h00m00s00f). (l 17) By repeatedly pressing the [COUNTER] Button on the Remote Controller, you can change the Counter Display Mode. ª To Display Date/Time Indication To display Date/Time Indication, set the appropriate Date/Time in [DATE/TIME] on the [DISPLAY SETUP] Sub-Menu. (l 17) You can also press the [DATE/TIME] Button of the Remote Controller repeatedly to display or change the Date/Time Indication. ª To Change the Display Mode By changing [DISPLAY] on the [DISPLAY SETUP] Sub-Menu, you can change the Display Mode to All Function Display [ALL], Partial Display [PARTIAL], and Minimum Display [OFF]. 47 CARD ERROR: This Card is not compatible with this Movie Camera. COPY INHIBITED: Because the medium is protected by a copy guard, images cannot be recorded correctly. CAN NOT CHANGE MODE: The Mode of the Movie Camera can not be changed in the PC connection Mode. DISCONNECT DV CABLE: If the Movie Camera is in Photo Title (CAMERA mode) and the DV Interface Cable is connected, "DISCONNECT DV CABLE" appears. [. . . ] 30 Surf & Snow Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 ªE Erasure Prevention Slider . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 ªF F Number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Fade . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]