User manual PANASONIC NVGS75

[. . . ] For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. Please contact your local authority for further details of your nearest designated collection point. [. . . ] Condensation can cause the lens to become dirty and lead to mold and malfunctioning, so exercise caution in the following situations: – When the camera is brought indoors from outside during cold weather – When the camera is brought into an airconditioned car – When cold air from an air conditioner is directly blown onto the lens – In humid places ≥ Put the camera into a plastic bag to allow it to acclimatize to the surrounding temperature in order to prevent condensation. If condensation occurs, turn the power off and leave it for about two hours. Once the camera acclimatizes to the surrounding temperature the condensation will go away naturally. Book 5 ページ ２０１２年１２月２１日　金曜日　午後６時２８分 Supplied Accessories [Inspection to be performed when you unpack the unit] When removing the unit from its packing box, check that the main unit and the supplied accessories are there and also check their external appearance and functions to verify that they have not sustained any damage during distribution and transportation. If you discover any trouble, contact your vendor before using the product. product numbers correct as of January 2013. Attaching/Detaching the Lens ≥ Refer also to the camera’s operating instructions for attaching and detaching the lens. ˆ Attaching the Lens ≥ Check that the camera is turned off. A: Lens Rear Cap 1 2 3 VYC1113 VYF3510 VFC4605 2 Align the lens fitting marks B (red marks) on the camera body and the lens and then rotate the lens in the direction of the arrow until it clicks. 1 Lens Hood 2 Lens Cap 3 Lens Rear Cap (The lens rear cap and lens cap are attached to the interchangeable lens at the time of purchase. ) • Do not press the lens release button C when you attach a lens. After zooming, please perform the focusing again. Cautions for Use 1 2 3 1 Lens surface 2 Focus ring Rotate to focus when taking pictures with manual focus. Take care not to drop or knock the lens. Also take care not to put a lot of pressure on the lens. ‰ Take care not to drop the bag that you inserted the lens in as it may strongly shock the lens. The camera may stop operating normally and pictures may no longer be recorded. When using pesticides and other volatile substances around the camera make sure that they do not get onto the lens. ‰ If such substances get onto the lens they can damage the exterior case or cause the paint to peel. Do not carry the unit when it is still attached to the camera body. ‰ Under no circumstances should the unit be stored in any of the following locations since doing so may cause problems in operation or malfunctioning. 4 5 3 Zoom ring Rotate the zoom ring when you wish to take large (tele) or wide (wide angle) pictures. [. . . ] ‰ This is the sound of lens or aperture movement and is not a malfunction. When this lens is attached to digital camera, stabiliser function cannot be turned off or stabiliser function does not work. ‰ The Optical Image Stabiliser function of this lens only works correctly with supported cameras. > When older Panasonic digital cameras (DMC-GF1, DMC-GH1, DMC-G1) are used, [Stabilizer] in the [Rec] mode menu cannot be set to [OFF]. [. . . ]