User manual PANASONIC NVGS75EF

[. . . ] Read the Safety Instructions booklet and the following before using. Exposure to noise can cause hearing loss. Use auxiliary handle supplied with the tool. loss of control can cause personal injury. [. . . ] After use, set the lever to its center position (switch lock). € When using at high speeds, set the clutch at 10 or below. (Operation stops at the maximum torque of 1. ) • The auto shut-off function may become inoperable at high clutch settings when battery power drops. Speed Selection Choose a low or high speed to suit the use. HIGH LOW Clutch Torque Setting Adjust the torque to one of the 21 clutch settings. Use for Drilling • When using for drilling, set the clutch at “ ” position. • Use a bit designed for drilling. The more the variable speed control trigger is pulled, the higher the speed becomes. CAUTION: • Check the speed selector switch before use. Indd 3 2013/01/30 15:49:17 • Use at low speed when high torque is needed during operation. Hooking tool [Battery Pack] For Appropriate Use of Battery Pack Li-ion Battery Pack • For optimum battery life, store the Li-ion battery pack following use without charging it. € When charging the battery pack, confirm that the terminals on the battery charger are free of foreign substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign substances are found on the terminals. The life of the battery pack terminals may be affected by foreign substances such as dust and water etc. € When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Shorting the battery terminals together may cause sparks, burns or a fire. € When operating the battery pack, make sure the work place is well ventilated. € When the battery pack is removed from the main body of the tool, replace the battery pack cover immediately in order to prevent dust or dirt from contaminating the battery terminals and causing a short circuit. The light illuminates with very low current, and it does not adversely affect the performance of the tool during use or its battery capacity. CAUTION: • The built-in LED light is designed to illuminate the small work area temporarily. € Do not use it as a substitute for a regular flashlight, since it does not have enough brightness. [. . . ] MAINTENANCE Use only a dry, soft cloth for wiping the unit. Do not use a damp cloth, thinner, benzine, or other volatile solvents for cleaning. In the event that the inside of the tool or battery pack is exposed to water, drain and allow to dry as soon as possible. Carefully remove any dust or iron filings that collect inside the tool. [. . . ]