User manual PANASONIC NV-GS85GC

[. . . ] 27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Please turn the camera on after removing the lens cap. When setting both the white balance and the iris/gain, set the white balance first. Whenever recording conditions change, re-set the white balance for correct adjustment. ª To set the white balance manually Select [ ] in Step 3. Then, while viewing a white subject on the entire screen, move the joystick up to select the [ ] indication. ª About flashing of the [ ] indication When the manual adjustment mode is selected Flashing indicates that the white balance previously adjusted is stored. This setting is stored until the white balance is adjusted again. When white balance cannot be set in the manual adjustment mode White balance may not be adjusted properly in the manual adjustment mode in dark places. During setting in the manual adjustment mode When the setting is completed, it will keep lit. ª About the white balance sensor The white balance sensor detects the type of light source during recording. Do not cover the white balance sensor during recording, or it may not function properly. ª Settings on the audio If you cannot listen to the desired audio when playing back a tape, check the settings in [SETUP] >> [12bit AUDIO]. When you record or dub the audio in [12bit] and set [SETUP] >> [12bit AUDIO] >> [MIX], the audio will be played back in stereo sound regardless of the settings in [AUDIO OUT]. 1 Operate with joystick. 1/;: Playback/Pause 6: Rewind/Review playback (Reverts to playback with the 1/; icon. ) 5: Fast forward/Cue playback (Reverts to playback with the 1/; icon. ) : Stop During cue/review playback, fast-moving images may show noise as a mosaic. Before and after cue/review playback, the screen may become blue for a moment or images may be disturbed. ª To adjust volume Adjust the speaker or headphone volume for playback. 1 Move the [s /VOLr] lever to adjust the volume. /VOL Slow-motion playback/ frame-by-frame playback Set to Tape Playback Mode. (Slow-motion playback can only be performed by using the remote control. ) Slow-motion playback If the image is recorded in the SP mode, then it will be played back at a speed approx. If the image is recorded in the LP mode, then it will be played back at a speed approx. 1 Press the [E] button or the [D] button on the remote control. V /REW PLAY FF/W W VOL W T STILL ADV PAUSE STILL ADV Towards [r]: increases the volume Towards [`]: decreases the volume (Nearer the bar to [r], larger the volume. ) On the remote control, press the [T] button to increase the volume or the [W] button to decrease it. When the adjustment is completed, the volume indication will disappear. If you do not hear the sound, check the settings of [SETUP] >> [12bit AUDIO]. STOP If the slow-motion playback continues for approx. 10 minutes or more, then the playback will automatically stop. [. . . ] This is called automatic white balance adjustment. However, since the movie camera only stores white colour information under several light sources, automatic white balance adjustment does not function normally under the other light sources. 10 000K 9 000K 8 000K 7 000K 6 000K 5 000K 1) 4 000K 3 000K 6) 7) 8) 9) 10) 2 000K 11) 12) 1 000K 2) 3) 4) 5) White balance adjustment determines the white colour under different light sources. By recognizing which is the white colour under sunlight and which is the white colour under a fluorescent lamp, the movie camera can adjust the balance among the other colours. Since white colour is the reference of all colours (light), the movie camera can record pictures in a natural hue if it can recognize the reference white colour. [. . . ]