User manual PANASONIC NV-GX7EG

[. . . ] The socket outlet shall be installed near the equipment and easily accessible or the mains plug or an appliance coupler shall remain readily operable. ª Carefully read the Operating Instructions and use the Movie Camera correctly. Injury or material damage resulting from any kind of use that is not in accordance with the operating procedures explained in these Operating Instructions are the sole responsibility of the user. Be sure to try out the Movie Camera before recording your first important event and check that it records properly and functions correctly. [. . . ] When a microphone is used for audio dubbing, use headphones to listen to the pre-recorded sound while dubbing the audio. (When using headphones , set [AV JACK] on the [AV IN/OUT SETUP] Sub-Menu to [OUT/PHONES]. ) When the line input is used, you can dub audio while listening to a pre-recorded sound from the speaker. For other notes concerning this item, see -86-. 1 AV Cable 2 S-Video Cable Be sure to press the [OSD] Button (-49-) on the Remote Controller prior to copying so that no indications are visible. Otherwise, the displayed tape counter and function indications are also copied. ) are required, please refer to the operating instructions of your VCR. After connecting the Movie Camera and the other equipment as illustrated, start the following procedures. For other notes concerning this item, see -86-. (Digital Dubbing) By connecting this Movie Camera with other digital video equipment that has a DV Input/Output Terminal using a DV Cable VW-CD1E (optional) 1, dubbing can be done in the digital format. For other notes concerning this item, see -86-. Input the Pin Number you have already selected. If the number is not correct, the screen will not change. If the number is correct, the contents of the setup will be displayed. You can change the Menu settings back to the shipping condition. When the Movie Camera is used for a long time, the Camera body becomes warm, but this is not a malfunction. If the [CHARGE] Lamp does not light up although the Battery is attached to the AC Adaptor, detach the Battery and reattach it. When the Movie Camera is left in the Recording Pause Mode for 6 minutes, it will be turned into the Quick Start Standby Mode. To turn the Movie Camera on again, set the [OFF/ON/MODE] Switch to [OFF] and then set it to [ON] again. (The Quick Start Mode will be restored. ) This Function is not activated when a tape is not inserted even if the Quick Start Recording Lamp lights: In the following cases, Quick Start is temporarily cancelled when the Quick Start Mode is set. set the Camera Mode again , and the Quick Start Mode will be restored. [. . . ] please use the Manual Focus Mode instead. 1) Recording a subject whose one end is located closer to the Movie Camera and the other end farther away from it Because Auto Focus makes adjustments at the centre of an image, it may be impossible to focus on a subject that is located in both foreground and background. 2) Recording a subject behind dirty or dusty glass Because the focus is on the dirty glass, the subject behind the glass will not be focused. 3) Recording a subject in dark surroundings Because the light information that comes through the lens decreases considerably, the Movie Camera cannot focus correctly. [. . . ]