User manual PANASONIC NVJ45EE

[. . . ] (Disconnect the aerial plug from the VCR during lightning storms. ) ­ Anything heavy on the VCR. ­ Connecting or handling the equipment with wet hands. Do: ­ Wipe the VCR with a clean and dry cloth. ­ Install the VCR in a horizontal position. [. . . ] Press the [DATE] button to set the date on which the TV programme will be broadcast. Press the [OK] button to display the programmed content. Press the [SP/LP/EP] button to set the desired tape speed. (For NV-FJ620 Series, NV-FJ621 Series and NV-FJ616 Series) ­ Regarding the [A] indication, refer to page 13. ­ To change timer recording programmings, use the [Cursor] buttons 3421, the [Channel], [DATE], [ON] or [OFF] button. ­ See page 13 for VPS/PDC recording. Press the [OK] button again to conclude the settings. Press the [TIMER] button to switch the VCR over to the timer recording standby mode. ­ Check that [Á] is lit on the VCR display. If it is flashing, check the timer recording details again. (See page 13. ) r DATE s r ON s Press the [ON] button to set the starting time. ­ When it is kept pressed, the indication changes in 30-minute intervals. ­ If the remaining tape time is still not sufficient even in the LP mode, the programme cannot be recorded to its end. ­ If the recording speed changes from SP to LP during a timer recording, some brief picture distortion occurs at that point. The total time indication for timer recording programming lets you check how many programmes can be Total (SP) recorded by comparing with the remaining tape time in the VCR display. ­ The total time is calculated in the SP mode. ­ The total time cannot be calculated when setting Daily/ Weekly timer recording. 90min VPS/PDC Function If a TV programme, for example a football game runs longer than scheduled, is shortened or starts earlier or later, this function synchronises the recording start and stop with the actual broadcasting start and stop of the TV programme. Press the [Cursor] buttons 3421 to make the [ON] indication appear. ­ [ON] must be displayed under [VPS/PDC] on the TV screen. ­ The TV station must broadcast VPS/PDC signals. ­ The programme starting time must be set correctly to the starting time listed in the newspaper/magazine. To Check, Change or Cancel Timer Recording Programmings PROG. / CHECK Press the [PROG. /CHECK] button to display the timer recording programmings on the TV screen. ­ When the VCR is in the timer recording standby mode for a VPS/PDC recording, the On Screen Display may be distorted. Press the [Cursor] buttons 34 to select the programming that you want to change or cancel. [. . . ] (For NV-FJ620 Series, NV-FJ621 Series and NV-FJ616 Series) ­ SQPB setting is not correct. (See page 17. ) ­ During high speed cue and review playback (JET SEARCH), the tape transport noise will increase. (For NV-FJ620 Series, NV-FJ621 Series and NV-FJ616 Series) Recording Is Not Possible or Does Not Work Properly [When recording is attempted, the 1 indication flashes. ] ­ A video cassette with a broken out erasure prevention tab is used. Use a cassette with an intact tab, or if you want to erase the previously recorded contents on the cassette, cover the tab hole with two layers of adhesive tape. [. . . ]