User manual PANASONIC NV-L25B

[. . . ] Refer to it for the control and component names and numbers which appear in the text. 1 X P 9 YZ POWER Í/I < EJECT X 2PULL-OPEN W STOP ¥ REC/OTR OFF TIMER Á PLAY /REW 6 DIRECT REC CVC TIMER REC SEARCH FF/ 5 Á [\ 6 ] ^_ D` 4 8H a b IN IN (AV1) OUT RF VIDEO OUT AUDIO c de f S R Q POWER VCR TV INPUT SELECT POWER Í 1 2 5 8 0 OSD INDEX P O N M L K J I H G F E D C B A VCR TV INPUT SELECT Í 1 4 7 AV SEARCH DIRECT REC 3 6 9 / DISPLAY 1 2 3 4 5 6 7 8 9 : o p = > ?@ J I VOLUME 2 5 8 0 OSD INDEX 3 6 9 / DISPLAY J I VOLUME 4 7 AV SEARCH DIRECT REC N i N i j V UW j G-CODE REC G-CODE REC K ;/D MENU L ENTER PICTURE MODE K ;/D MENU L ENTER PICTURE MODE T 6 6 6 6 CH DATE ON OFF CH DATE ON OFF J 1 I i 2 j i 3 j i 4 j J 1 I i 2 j i 3 j i 4 j PROG. /CHECK CANCEL RESET REPEAT AUDIO OUT SPEED TIMER REC PROG. /CHECK CANCEL RESET REPEAT AUDIO OUT SPEED TIMER REC Á VCR/TV Á VCR/TV 3 Contents As this equipment gets hot during use, operate it in a well ventilated place; do not install this equipment in a confined space such as a book case or similar unit. Before Use Positions of Controls and Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Introduction to Controls and Components . . . . . . . . . . . . . . . . . . . . . . . . . 5 Preparing the Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 3. 58: For TVs that can receive NTSC 3. 58 signals. ¡ NTSC 3. 58 recording requires "NTSC INPUT SELECT" to be in the "AUTO" or "3. 58" position (see page 15), however if "NTSC INPUT SELECT" is in this position when recording a NTSC 3. 58 signal, no colour is available for the PAL TV. Once the recording is completed, you then need to select "on PAL TV" to view the recording in colour on PAL TV. When playback the PAL tapes: You do not need to set "NTSC PB SELECT". Note for only NTSC Playback on PAL system TV This function is designed to allow only the playback of tapes recorded by NTSC signals on a PAL system TV. The NTSC signal is not completely converted to a PAL signal. For this reason, images played back by this function cannot be recorded correctly on other VCRs. Notes: Cue, review or slow playback will be automatically cancelled after 10 minutes, and still playback after 5 minutes. On some TVs, the playback picture may roll up or down; adjust this using the V-HOLD control on the TV. TVs not equipped with a V-HOLD control cannot correct this condition. The playback picture may shrink vertically, and black bars may appear both on the top and bottom of the screen. 2 VCR display 1 Insert a video cassette with an intact erasure prevention tab. If it has already been inserted, press the POWER button 1 to turn the VCR on. Select the TV station using the Channel button P. It is also possible to select by pressing the Numeric buttons 2. Press the REC (REC/OTR) button K (`) to start recording. REC 2 Press the DISPLAY button N repeatedly until the Remaining Tape Time appears on the VCR display. REMAIN 3 4 Pressing the DISPLAY button N once makes the VCR display appear; after that, pressing it repeatedly changes the indication in the following order: Clock Counter Remaining Tape Time For certain cassettes, the remaining tape time may not be displayed correctly. Press the Stop button 9 to stop recording. Press the SPEED button E before recording. SP provides standard recording time, optimum picture and sound quality. LP provides doubled recording time with SP slightly reduced picture and sound quality. EP provides tripled recording time with slightly reduced picture and sound quality. When you play back a tape recorded in the EP mode, the monaural sound may be unstable. When you start the recording the EP mode, "EP" indication on the VCR display flashes for about 8 seconds. EP mode means Super Long Play (SLP). To Pause Recording Press the Pause/Slow button 7 during recording. [. . . ] There are no user serviceable parts inside. Avoid Water Keep the VCR away from flower vases, tubs, sinks, etc. If liquids are spilled into the VCR, serious damage could occur. If you spill any liquid into the VCR, consult qualified service personnel. [. . . ]