User manual PANASONIC NV-SV120EB

[. . . ] Condensation Precaution This VCR is not fitted with a condensation sensor. If you bring in the VCR from a cold place, e. g. a car, into a warm house, dew may form inside the VCR. [. . . ] The [S] in the [S-Video Socket] stands for [SEPARATED Y/C] not for [S-VHS]. VCR Aerial Input socket Audio Output sockets S-Video Output socket Aerial Audio Input sockets TV with S-Video Input socket AC Input socket Aerial Output socket Audio cables Aerial Input socket RF Cable AC Mains lead S-Video cable S-Video Input socket To AC Mains socket After completing the above connections, proceed to the Auto Setup page (Page 5). -4- Auto Setup START 1 VCR Display VCR TV Set the VCR/TV switch to VCR. Turn on the TV, then press the Standby/ON button to switch on the VCR. The first digit of the VCR display will begin to flash. After a while, it will stop flashing and the RF output channel number will be displayed. If you have connected the VCR to the TV with a Scart cable, you will see the screen on the right during Auto Setup. You can skip step 2 below. On-Screen Display Auto-Setup Tuning : Ch 21 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 2 EXT LINK TV ASPECT TV/TEXT TRACKING/V-LOCK 1 4 INPUT SELECT CH VOLUME INDEX VIDEO Plus+ REC Select an unused channel pre-set on your TV and tune it to the RF output channel number shown on the VCR display (or until you can clearly see the Auto Setup screen shown on the right). Store the new video playback channel (refer to the instructions for your TV). If you can see interference on the picture, you may need to change the RF output channel. Follow the instructions on page 6 to do this. You can complete the Owner ID now or skip this step and do it later. To do it later, press the EXIT button again. To set the Owner ID now, press the Numeric buttons or Cursor buttons ( ) to enter a four-digit PIN number. If you make a mistake, press the Cursor button ( ), then enter the correct digit. Make sure that you will remember the PIN number (make a note of it). [. . . ] (For example, if the original channel number was 28, enter 31. ) Set the RF output channel of the VCR to [- -] (RF OFF) if the VCR is connected to the TV via the 21-pin Scart cable. Press the 0 numeric button or Channel button to display [- -]. Skip step 4, if using a 21-pin Scart cable. 21 . . . [. . . ]