User manual PANASONIC NV-VZ10ENC

[. . . ] To replace the fuse, open the fuse compartment with a screwdriver as shown and replace the fuse and the cover securely. Fuse cover 1. Open the fuse cover with a screwdriver. ! 2. Replace the fuse and close or attach the fuse cover. Fuse (5 ampere) ! To prevent electric shock, do not remove cover. Refer servicing to qualified service engineer only. [. . . ] ! : select : return : exit ! With select the name entry. The cursor will mark the first letter BBC1. The new name will be stored in Tuning. Tuning Pos Name 1 2 3 4 5 A Changing the order of TV stations or deleting a station Ch 22 23 24 25 26 B ENTER EXIT Pos Name Ch 6 7 8 9 10 ------------30 --------- !! BBC1 BBC2 ITV CH4 CH5 : delete move MENU : return : move : store : exit Press MENU, the Menu screen appears. With select the Tuning menu, confirm with ENTER. An arrow to the left will mark the selected field. With move the station to any other desired location. Press A to delete the station. 34 Manual Functions Tuning Manual Auto Setup Shipping condition Owner ID OK? ENTER : yes EXIT : no Creating a new station table !! Press MENU, the Menu screen appears. With select the Tuning menu, confirm with ENTER. With select [Auto Setup], confirm with ENTER. Use the Numeric buttons or to enter the current PIN number. After entering the correct PIN number, you can change the Name, House No and Postcode. Use , the Numeric buttons and ENTER to select and change the desired information. Press EXIT to exit the On Screen Display. Owner ID PIN number Name House No Postcode : 846* : ************** : *********** : *********** !! ! Owner ID Name House No Postcode : MARWIN : BANKS : RG12 8FT EJECT To display the Owner ID information on TV ! Keep EJECT pressed for more than 5 seconds. After 30 seconds, this menu automatically disappears. D 37 Manual Functions Menu Timer recording Tuning Clock set Others Clock setting The clock will normally be set correctly during Auto-Setup however, in some circumstances the VCR cannot set the clock automatically. In this case, follow the operation steps below to manually set the clock. Confirm that Clock set is set to MANUAL, and press ENTER. Use or Numeric buttons to set the Date and Time. Press EXIT to exit the On Screen Display. EXIT :select : exit ENTER : access To activate the automatic time correction function The correct time for the VCR clock can be automatically maintained when the VCR is tuned to a station that transmits a time signal. Under adverse reception conditions, etc. , the Automatic time correction function may not work. [. . . ] If flashes on the device, check if the protection tab of the video cassette is still in. Check the start and stop time of the timer programme. Check if the TIMER button has been pressed to put the device into timer mode after programming a recording. Check the start and stop time of a PDC recording. 38 27 28 The recording functions do not work properly: ! [. . . ]