User manual PANASONIC PT-L6500

[. . . ] You should note it in the space provided below and retain this booklet in case service is required. Power Supply: This LCD Projector is designed to operate on 100 V ­ 240 V, 50 Hz/60 Hz AC, house current only. CAUTION: The AC power cord which is supplied with the projector as an accessory can only be used for power supplies up to 125 V, 7 A. If you need to use higher voltages or currents than this, you will need to obtain a separate 250 V power cord. [. . . ] The projector is preparing for projection after the power has been turned on while the POWER button on the projector is illuminated red. (After a short period, a picture will be projected. The lamp is cooling down after the power has been turned off or while direct power off function is operating. The projector is preparing for projection after the power has been turned on while the POWER button on the projector is illuminated orange. (After a short period, a picture will be projected. This projector detects its degree of tilt and the input signal. Keystone distortion and the position of the image can then be corrected automatically in accordance with the input signal. ) B When RGB signals are being input, "DOT CLOCK", and "CLOCK PHASE" will be adjusted automatically in addition to keystone distortion and the position of the image being corrected (except when the dot clock frequency is 100 MHz or higher). B If the edges of the projected image are indistinct, or if a dark picture is being projected, the automatic setup processing may stop automatically before it is complete. If this happens, project a different picture and then press the AUTO SETUP button again. B Set "AUTO KEYSTN" in the "OPTION" menu to "OFF" to prevent any deterioration of the picture as a result of keystone correction. This projector has unadjustable items and unusable functions depending on the signal being input. When an item cannot be adjusted or a function cannot be used, the corresponding on-screen menu display does not appear, and the item or function will not work even if the ENTER button is pressed. The bar scale will turn green when any adjustment changes the setting from the factory set value. If you press the STD (standard) button on the remote control unit, you can return settings to the factory default settings. However, the operation of this function varies depending on which screen is being displayed. B When a menu screen is being displayed B When an individual adjustment screen is being displayed All items displayed will be returned to their factory default settings, "STD" will be displayed in the topright screen and the bar scale will appear white. NOTE: B You can also select "STANDARD" from the menu screen and then press the ENTER button. NOTE: B Triangle symbols above and below the bar scale indicate the factory default setting. Items which do not have these triangle symbols cannot be returned to the factory default setting. Only the item displayed will be returned to the factory default setting, and the bar scale will appear white. Keystone distortion is corrected automatically when the projector's automatic setup function is used, but this correction will not apply if the screen itself is tilted. [. . . ] Use a blower to clean any dust and lint from the lens surface, or use a soft cloth to wipe off any dust or lint. Power supply: Power consumption: Amps: LCD panel: Panel size (diagonal): Aspect ratio: Micro lens array: Display method: Drive method: Pixels: Lens: 100 V - 240 V ~, 50 Hz/60 Hz 300 W [During standby (when fan is stopped): Approx. 11 b/g Connectors RGB IN/OUT: Dual line, D-sub HD 15-pin (female) (One line is available for input and output, selectable using an on-screen menu) During YPBPR input/output: Y: 1. The following symbols are used to indicate picture quality. [. . . ]