User manual PANASONIC PT-VZ570

[. . . ]  Functional Manual PT-VZ570 PT-VW530 PT-VX600 Thank you for purchasing this Panasonic Product. –■ This manual is intended for products manufactured from Jan. –■ Before operating this product, please read the instructions carefully, and save this manual for future use. –■ Before using your projector, be sure to read “Read this first! [. . . ] Adjusts according to the lens shift range in the horizontal or vertical direction. Adjustment [VERTICAL BALANCE] [HORIZO Adjusts the balance according to the amount of the vertical lens shift adjustment. 5) Press as to select the item to adjust, then press the <ENTER> button. 5) Press as to select the item to adjust, then press the <ENTER> button. Adjusts when the trapezoid of the projected image is distorted. Adjusts when the radian of the projected image is distorted. Adjusts when the balance of the projected image is distorted. Set to [ON], maintain the aspect ratio when correct the curved distortion of the projected image. When [KEYSTONE], [CORNER CORRECTION] or [CURVED CORRECTION] adjustment is finished, you adjust the others, the adjusted value will be reset. Ff Press the <SCREEN ADJ> button on the remote control when the [KEYSTONE], [CORNER CORRECTION] or [CURVED CORRECTION] screen is displaying, it will switch to the next adjustment screen. Ff When the [CORNER CORRECTION] individual adjustment screen is displaying, the individual adjustment screen of the next corner can also be displayed by pressing the <ENTER> button. Ff Correcting up to ±25° for the tilt in the vertical direction and ±30° for the tilt in the horizontal are available for adjustments with [KEYSTONE]. However, the image quality will degrade and it will get harder to focus with more correction. Install the projector so that the correction will be as small as possible. Ff Screen size will also change when [KEYSTONE] is used to perform various adjustments. Ff Aspect ratio of the image size may shift depending on the correction. [SHIFT] (Only for computer (RGB) signals and YCBCR/YPBPR signals input) Move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relative position of the projector and the screen is installed correctly. [DOT CLOCK] (Only for computer (RGB) signals input) Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes. The projection of the striped pattern may cause cyclic patterns (noise). adjust so that the amount of interference is at a minimum. [CLOCK PHASE] (Only for computer (RGB) signals and YCBCR/YPBPR signals input) You can adjust to achieve an optimal image when there is a flickering image or smeared outlines. Ff Optimal value may not be achieved if the output from the input computer is unstable. [. . . ] A signal with a different resolution will be projected after converting the resolution to match the projector display. ff “i” added to the resolution value indicates an interlaced signal. Ff When interlaced signals are connected, flicker may occur on the projected image. Ff Even the above signals exist, some image signals that recorded in special method may not be displayed. [. . . ]