User manual PANASONIC PV-945H

[. . . ] Never spill liquid of any kind on the product. Read instructions All the safety and operating instructions should be read before the product is operated. Retain instructions The safety and operating instructions should be retained for future reference. Heed warnings All warnings on the product and in the operating instructions should be adhered to. Follow instructions All operating and use instructions should be followed. Servicing Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. [. . . ] Non-guaranteed shows can borrow the space reserved for guaranteed channels if the guaranteed channels don't have episodes recorded in them. 40 PanaHDR- P22-. p65 40 00/12/01, 16:40 Guaranteed Record and Space-available Record When you guarantee recording of a future show, recording space is immediately set aside. For this reason, the size of your recording space limits the number of shows you can guarantee. A guaranteed record places solid red dots next to the show-based recording in the Channel Guide. When you don't guarantee a future show for recording, the show uses whatever space is available at the time it is recorded. If there is no unused space available at the time, the show may not be recorded. A non-guaranteed (space-available) record places hollow red dots next to the show in the Channel Guide. There is no limit to the number of non-guaranteed recordings you can set. To increase the likelihood of your non-guaranteed shows being recorded, delete viewed shows from the Replay Guide after you have watched them. The time that is reserved for the Show-based channel that you just deleted can be used for non-guaranteed shows. Although, if another episode of the guaranteed show is about to air, it will reclaim its reserved recording space that was borrowed by the non-guaranteed recording. Recording Space Management Tips Here are some space saving tips to make sure the Hard Disk Recorder records what you want. Use the Guaranteed record setting for your can't-miss shows Use the Guaranteed setting for the shows you can't afford to miss. Then, go ahead and use the non-guaranteed setting for other shows. or VCR/DVD* to select your * If you want to operate TV or TV/VCR Combo volume control, press TV. If Satellite or Cable Box, press SAT/ CABLE. If VCR, TV/VCR Combo, or DVD, press VCR/DVD. c Hold down CODE SET until the remote's red LED blinks twice, then release. NOTES · Remember, if you want to use your Hard Disk Recorder remote to operate your component, press the component's mode button first. For example, press TV first if you want to operate your TV. · The remote control will not operate all components made by manufactures listed. If you get no response, your particular brand cannot be controlled. Number Buttons to enter the first four digit d Pressof your component brand on pages 45~49. code · If you perform this procedure correctly, the red LED will blink twice when you enter the final digit of your code. e Point the Hard Disk Recorder remote at your component, then press POWER. Your component should turn off. · If your component does not respond, repeat steps b-e, trying each code listed for your brand until you find the one that operates your component. 42 PanaHDR- P42-. p65 42 00/12/01, 16:40 Searching for Your Component's Code If your component does not respond to the Hard Disk Recorder remote after trying all of the codes listed for your brand, or if your brand is not listed, try searching for your code. For example, if you try all of the codes for your TV and cannot get the Hard Disk Recorder remote to operate your TV, follow steps below. 1 2 3 4 5 Turn on your TV with the Hard Disk Recorder off. Hold down CODE SET until the remote's red LED blinks twice, then release. Slowly alternate between pressing POWER* and TV until your TV turns OFF. · Make sure that the Hard Disk Recorder remote is aimed at your TV during the search. [. . . ] See "Setting Up Your Components" on page 42. Hard Disk Recorder Puts the remote control in the Hard Disk Recorder mode, giving you control of the Hard Disk Recorder features and functions. TV 20 SAT/CABLE 21 VCR/DVD Puts the remote control in a particular mode--to operate your television, satellite receiver, cable box, VCR, DVD, TV/VCR Combo, or laser disk. If a component does not respond when you press a remote control button (or responds incorrectly), press the appropriate device button (HARD DISK RECORDER, TV, SAT/CABLE, VCR/DVD) first to choose which component to operate. [. . . ]