User manual PANASONIC PV-M2038

[. . . ] To obtain maximum benefit from your set, please read these Instructions before making any adjustments, and retain them for future reference. Retain your purchase receipt also, and note down the model number and serial number of your set in the space provided on the rear cover of these instructions. Visit our Panasonic Web Site http://www. panasonic. co. jp/global/ Trademark Credits VGA is a trademark of International Business Machines Corporation. Macintosh is a registered trademark of Apple Computer, USA. [. . . ] Always use new batteries when replacing the old set. Do not combine a used battery with a new one. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"). Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity. (3) The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will need to make setting changes to the computer at the time of connection. (4) Some PC models cannot be connected to the set. (5) There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal. (6) The computer shown in the illustration is for example purposes only. (7) Additional equipment and cables shown are not supplied with this set. (see page 18) PC button Press the "PC" mode selection button to select the PC mode. OFF TIMER button This button is used to switch The Plasma Display can be preset to switch to stand-by after a fixed period. The setting changes to 30 minutes, 60 minutes, 90 minutes and 0 minutes (off timer cancelled) each time the button is pressed. 30 60 When three minutes remain, "Off timer 3" will flash. 0 The off timer is cancelled if a power interruption occurs. 90 13 Power On/Off and input signal selection AC cord connection Connecting the AC cord plug to the Plasma Display. Power On/Off Connecting the plug to the Wall Outlet Note: Main plug types vary between countries. The power plug shown at left may, therefore, not be the type fitted to your set. R - STANDBY G POWER ON INPUT -- VOL + Press the Power switch on the Plasma Display to turn the set on: Power-On. Power Indicator: Green R - STANDBY G POWER ON TH-50PHD5 Power Indicator Remote Control Sensor Example: The screen below is displayed for a while after the Plasma Display is turned on. (setting condition is an example. ) From the second time on, the below screen is displayed for a while (setting condition is an example). When the Power is turned on for the first time, the Language selection screen is displayed. From the second time on, language selection can be done from the setup menu. (see page 15) Select the desired language using the and keys and press the ACTION button. OSD Language English (UK) Deutsch Fran ais Italiano Espa ol ENGLISH (US) AV 4:3 Select Set INPUT Press the button on the remote control to turn the Plasma Display off. Power Indicator: Red (standby) Press the button on the remote control to turn the Plasma Display on. [. . . ] on VIDEO: Compatible with the scart plug (Europe) The composite video signal input from the VIDEO input terminal is used by dividing the sync signals. Sync H&V Sync on G Sync on VIDEO Setting PC sync signal: Confirm that the input is set to PC input (this setting is valid only for PC input). H & V: The H and V sync signals are input from the HD/VD connector. on G: Uses a synchronized signal on the Video G signal, which is input from the G connector. Sync H&V Sync on G H-Freq. (Hz) Displays the H (Horizontal)/V (Vertical) frequencies. This display is valid only for RGB input and PC input. [. . . ]