Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PANASONIC RC-CD300. We hope that this PANASONIC RC-CD300 user guide will be useful to you.
Lastmanuals help download the user guide PANASONIC RC-CD300.
Detailed instructions for use are in the User's Guide.
[. . . ] IMPORTANT SAFETY INSTRUCTIONS
Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the safety precautions listed below. Keep these operating instructions handy for future reference.
Safety
1. Power source--Connect the unit to a power source of the type described in these instructions or as marked on the unit. [. . . ] (Do not use CDs with exposed adhesive from tape or left over peeled off stickers. )
Do not use scratch-proof protectors or covers other than those specified for use with this unit.
Storage precautions
Be sure to store CDs in their cases to protect them from dust, scratches, and warping. Do not place or store CDs in the following places Locations exposed to direct sunlight Humid or dusty locations Locations directly exposed to a heat vent or heating appliance In the glove compartment or on the rear deck of an automobile
2
Controls
CD, Radio
Setting the time
Reset the clock regularly to maintain accuracy. (Monthly accuracy +/-30 seconds) This is a 12-hour clock. This example shows how to set the clock for 10:30 A. M. CD lid open button (PUSH, OPEN/CLOSE)
CD play mode, FM mode button (MODE)
CD
CLOCK
RADIO
Dial display
CD lid
DOZE
RC-CD300
FM
C D C L O C K R A D I
88 53
AL 2 / -SET
92 60
MODE
96 100 104 130
108 170
MHz X10 kHz
AM
DISP / -TIME SET AL 1 / -SET
70 80 100
SLEEP
D O Z E
O
OFF
RADIO
CD
FM/AM
RC-C
D300
FM
DISP / -TIM
88
E SE T AL 1 / -S
AM
ET AL 2 / -S ET
92 53 60
MODE
96
100 10
70 80
SLEE P
104 108
L VO UM E
1, 3
0 17 0 MHz X10 kHz
NI NG TU
2
AM
OF
0
F
13
RA
FM
DIO
/AM
CD
Stop button (, OFF) Radio on, band select button (FM/AM, RADIO) CD play, pause button (1/ ;, CD) Skip, search buttons (s, r, :/6, 5/9) Tuning dial (TUNING) Volume control (VOLUME)
1 2 2 2 3
Press and hold [DISP/-TIME SET] until the time display flashes.
Press [i, 5/9] or [j, :/6] to adjust the time.
[i, 5/9]: Increases the time by one-minute units. [j, :/6]: Decreases the time by one-minute units. The time changes faster if you hold [i, 5/9] or [j, :/6] down.
Press [DISP/-TIME SET].
The time is set.
AM
Alarm, Sleep timer and Basic operations
Display, time set button (DISP/-TIME SET) CD/Radio alarm setting buttons (AL 1/-SET) Buzzer alarm setting buttons (AL 2/-SET) Display Doze button (DOZE) For your reference: When you play a CD, the display changes but the clock is displayed again after about 10 seconds. The light in the main unit's display comes on for about 5 seconds when you press a button.
C D C L O C K R A D I
D O Z E
O
RC-C D3
00
FM
DISP / -TIM
88
E SE T AL 1 / -S
AM
ET AL 2 / -S ET
92 53 60
MODE
96
100 10
70
104 108
LU ME
80
OF
F
SLEE P
0
13
0 17 0
MHz X10 kHz
NI NG
VO
RA
FM
DIO
/AM
CD
TU
Stop button (, OFF) Sleep timer button (SLEEP) Time adjust buttons (s, r, :/6, 5/9)
3
Listening to CDs
1, 2
C D C O L C K R A D O I
Other play methods
CD
CLOCK
RADIO
DOZE
O D Z E
RC-CD300
RC-C D3
00
FM
DIS P / -TI ME
88
SET AL 1
AM
/ -S ET AL 2 / -S ET
92 53 60
MODE
96
FM
100 10 104 108 0 13 0 17 0 MHz X10 kHz
NI NG
VO LU ME
DISP / -TIME SET
88 53
AL 2 / -SET
92 60
MODE
96 100 104 130
108 170
MHz X10 kHz
70
SLEE
80
P
AM
AL 1 / -SET
70 80 100
SLEEP
OF
F
RA
OFF
RADIO
CD
FM
DIO
/AM
CD
FM/AM
TU
OFF
MODE
CD
OFF
3
1
4
Press [PUSH, OPEN/CLOSE] to open the CD lid and insert the CD.
Preparation for skip play and random play 1. Each time [SLEEP] is pressed 30(min. ) 60 ) 90 ) 120 ) ^------------ OFF ------------} ª To release the timer Press [SLEEP] to select "OFF".
SLEEP
1
Press [FM/AM, RADIO] to select the band.
Each time [FM/AM, RADIO] is pressed FM ) AM ^----------n
AM
FM
ª To check the remaining time Press [SLEEP] once. The time display is restored after the remaining time is displayed. ª To change the remaining time Press [SLEEP] to display the remaining time then press again to change the time.
2
Turn the dial to tune to the desired station.
" " lights up when the station is tuned in.
AM
FM
3
Adjust the volume.
For your reference: You can combine the alarm and sleep timer. Be sure the volume is at an appropriate level before you turn the unit off.
ª To turn off Press [, OFF].
To improve reception
FM
Extend and change the direction of the antenna lead.
AM
CD
CLOCK
RADIO
CD
CLOCK
RADIO
DOZE
DOZE
RC-CD300
RC-CD300
FM AM
DISP / -TIME SET AL 1 / -SET AL 2 / -SET
88 53 60
92
96 100 104 130
108 170
MHz X10 kHz
DISP / -TIME SET
FM AM
AL 1 / -SET AL 2 / -SET
88 53 60
92
96 100 104 130
108 170
MHz X10 kHz
70 80 100
SLEEP
70 80 100
SLEEP
MODE
MODE
OFF
RADIO
CD
OFF
RADIO
CD
FM/AM
FM/AM
ª If noise is excessive in the FM stereo mode Press [MODE]. "MONO" lights up.
CD
CLOCK
RADIO
DOZE
RC-CD300
AM
FM AM
DISP / -TIME SET AL 1 / -SET AL 2 / -SET
88 53 60
92
96 100 104 130
108 170
MHz X10 kHz
70 80 100
SLEEP
MODE
OFF
RADIO
CD
FM MONO
FM/AM
MODE
Sound will be produced in monaural, but this also reduces noise. ("MONO" goes out. )
5
RQTT0530
Using the alarm
You can set the unit to come on at a set time and play a CD, the radio or a buzzer. The unit turns off automatically after one hour. (Refer to page 3 "Setting the time")
Setting the CD/Radio alarm (ALARM 1)
AL 1 / -SET
Setting the buzzer alarm (ALARM 2)
1, 3
CD CLOCK RADIO CD CLOCK RADIO
DOZE
DOZE
RC-CD300
RC-CD300
FM AM
DISP / -TIME SET AL 1 / -SET AL 2 / -SET
88 53 60
92
96 100 104 130
108 170
MHz X10 kHz
DISP / -TIME SET
FM AM
AL 1 / -SET AL 2 / -SET
88 53 60
92
96 100 104 130
108 170
MHz X10 kHz
70 80 100
SLEEP
70 80 100
SLEEP
MODE
MODE
OFF
RADIO
CD
OFF
RADIO
CD
FM/AM
FM/AM
DISP / -TIME SET
OFF
CD
DISP / -TIME SET
OFF
2
PM
AL 2
CD
1 2 2 2 3
Press and hold [AL 2/-SET]
until the display flashes.
1 2 3 4 2 2 5 6 1 2 3 4 5
Press [1/ ;, CD] to start play. Press [i, 5/9] or [j, :/6] to select the desired track. Press and hold [AL 1/-SET] until the display flashes.
CD
Press [i, 5/9] or [j, :/6] Example: set the alarm time for "7:00 AM". to adjust the alarm time.
[i, 5/9]: Increases the time by one-minute units. [j, :/6]: Decreases the time by one-minute units.
AM
PM
AL 1
AL 2
Press [i, 5/9] or [j, :/6] to adjust the alarm time.
[i, 5/9]: Increases the time by one-minute units. [j, :/6]: Decreases the time by one-minute units.
Example: set the alarm time for "7:00 AM".
AM
CD
The time changes faster if you hold [i, 5/9] or [j, :/6] down.
Press [AL 2/-SET].
The alarm time is set and "AL 2" is indicated on the display.
AL 1
The time changes faster if you hold [i, 5/9] or [j, :/6] down.
Note
PM
AL 2
Press [AL 1/-SET].
The alarm time is set and "AL 1" is indicated on the display .
CD
PM
AL 1
You cannot adjust the volume of the buzzer alarm. ª To shut off the alarm Press [, OFF]. [. . . ] Damage requiring service--The unit should be serviced by qualified service personnel if: 1. (a) The AC power supply cord or AC adaptor has been damaged; or 1. (b) Objects or liquids have gotten into the unit; or 1. (c) The unit has been exposed to rain; or 1. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC RC-CD300
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC RC-CD300 will begin.