User manual PANASONIC RF-U300

[. . . ] To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from AC receptacle. This can overload the unit and cause a fire. Ensure the AC power supply code is connected correctly and not damaged. Poor connection and code damage can cause fire or electric shock. [. . . ] Stops at the station which is tuned in first. Repeat this until the station you want to listen to is tuned in. In standby mode, the unit is still consuming a small amount of power. Making it easier to understand what's being said (RF-U350 only) You can adjust the speed of what's being said to understand newscasts, the dialogue of characters in dramas, etc. Note If you take hold of the unit's rod antenna and move it from one place to another, you may damage the unit. To move the unit, make sure you pick it up by the handle on the rear panel, and then move it. To close the slow speech function, press the button again. (The indicator around Note · When the slow speech function is activated, the sound quality will automatically be switched to NORMAL and cannot be changed. ⷠThe slow speech function effects may not be obtained with some music programs and other broadcast content. ⷠThe slow speech function is released in the following cases: (1) When the power is turned off (2) When you have changed the station you are now listening to · When the slow speech function is set to ON, the tone quality will change, and there will be a delay in the sound heard. ⷠThe speed of the slow speech function cannot be changed. ⷠWhen the slow speech function is set to ON while the reception is poor and accompanied by a lot of noise, the noise will be amplified, making the sound hard to listen to. This unit can display the text data transmitted by the radio data system (RDS) available in some areas. the panel display is automatically switched when a Program Service name (PS) or Radio Text message (RT) is received. When a Program Service name (PS) is received When a Radio Text message (RT) is received During timer operations the unit will not automatically switch over to the RDS displays. Different ways to use the unit Listening to sound via earphone (not included) Turn the volume down before connecting the earphone. Note Avoid listening for prolonged periods of time to prevent hearing damage. Using the sleep timer The unit's power is automatically turned off when the set time is reached. Each time this button is pressed, the position of " " changes. Each time the button is pressed, the setting changes in the following sequence: 30 (minutes) 60 90 120 OFF (released) M U S I C - Set to this position to enjoy music. To display how much time remains until the set time Press . Remaining time Note When the power is turned on again, the broadcast station that was last tuned in when the power was turned off, will be tuned in. [. . . ] Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer upon the purchase of an equivalent new product. Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ]