User manual PANASONIC RP-WF6000H

[. . . ] Before connecting, operating or adjusting this product, please read the instructions completely. Please keep this manual for future reference. For optimum performance and safety, please read the instructions carefully. RP-WF6000H headphones are designed to be used together with the RP-WF6000 digital wireless surround headphones (sold separately). [. . . ] The range may be less depending on the structure of the building, the environment and any obstacles between the headphones and the transmitter. Use the supplied rechargeable battery or "LR6, AA" alkaline dry cell batteries (not included). The power turns on automatically and the OPR lamp lights when you put on the free-adjusting band. pull up the free-adjusting band and check that the OPR lamp glows red. Please call 0870 240 6284 or visit our website www. The supplied rechargeable battery must be charged before using this unit. For your reference The transmitter will automatically stop emitting radio waves if headphones are left on the transmitter. Be sure to take the headphones off the transmitter when using other headphones at the same time. The headphones can be used even if the battery is not fully charged. Charge the battery in an environment with an ambient temperature between 0 °C and 40 °C or it may not be fully charged. Press the [BATT] knob on the left housing a to open the battery compartment lid b and then take it off. Push down on the - pole spring when inserting Remove the + poles first when removing. To charge the battery after using the headphones To check the remaining battery power Check that the left and right sides of the headphones are correctly placed on the left and right sides of the transmitter. Check that the charging terminals on the headphones and transmitter are touching each other. When there is dirt on the charging terminals of the headphones or the transmitter, remove it gently with a cotton bud, etc. Put the headphones back on the transmitter. Insert the rib c on the battery compartment lid into the hole on the left housing and then close the battery compartment lid. Push the battery compartment lid until it locks. This means that the battery has run down and should be charged or replaced. If the sound is distorted, intermittent or there is excessive background noise while using the headphones, the battery should be charged or replaced. the supplied nickel-metal hydride rechargeable battery can be recharged approximately 300 times. If the operation time of the battery becomes extremely short after charging, the battery's service life has reached the end. [. . . ] When the headphones are used outside the range of the radio waves or the radio waves weaken, the sound is broken. move nearer to the transmitter or reset the frequency ( page 8 [Setting the most appropriate frequency]). 4 GHz radio frequency band, obstacles (such as reinforced concrete walls and metal doors) may cause the sound to be broken. This is a characteristic of radio waves and not a malfunction. [. . . ]