User manual PANASONIC RP-WH5000

[. . . ] Before connecting, operating or adjusting this product, please read the instructions completely. Please keep this manual for future reference. For optimum performance and safety, please read these instructions carefully. Read these operating instructions carefully before using the unit. [. . . ] Put the headphones back on the transmitter. The DECODE MODE lamp goes out approximately 1-2 seconds later and charging begins. It takes approximately 16 hours to charge the supplied batteries. The unit's internal timer will stop charging when the batteries are fully charged so leaving the headphones on the transmitter will not cause battery overcharging or damage to the unit. The charging takes approximately 16 hours even if the batteries are not fully discharged. ⷠIf you take the headphones off the transmitter while charging or after charging has finished, the charging will again take approximately 16 hours when you put the headphones on the transmitter. Use the supplied optical digital cable to connect a television or DVD player's optical DIGITAL AUDIO OUT terminal*1 to the transmitter's DIGITAL IN terminal*2. Optical digital cable (supplied) Remove the plug caps and insert the cable firmly into the correct terminals. Equipment such as a DVD recorder with an optical DIGITAL AUDIO OUT terminal Equipment such as a portable DVD recorder with an optical mini DIGITAL AUDIO OUT terminal This means that the batteries have run down and should be replaced or charged. If the sound is distorted, intermittent or there is excessive background noise the batteries should also be replaced or charged. *1 Operation is not guaranteed when connecting to a computer's optical DIGITAL AUDIO OUT terminal. *2 When the connected equipment supports PCM output only, the surround sound will become DOLBY PRO LOGIC Optical digital cable (optical mini plug) (not included) When connecting the optical DIGITAL AUDIO OUT terminal of, for example, a portable DVD player or portable CD player to the transmitter's DIGITAL IN terminal, use the optional digital cable (mini plug to angular plug) or similar. Put the headphones on the transmitter making sure that the charging terminals are in contact with each other. Service life for rechargeable batteries If the duration of use for the supplied nickel-metal hydride rechargeable batteries is half the usual time after charging, the batteries have reached the end of their service life. Do not let falling objects subject the optical digital cable to vibration or shock. ⷠHold the plugs in your hands and carefully connect or disconnect the optical digital cable. ⷠIf the ends of the optical digital cable become dirty or dusty, efficiency will decrease. For safety reasons, attach plug caps and do not bend the optical digital cable too much. When the sound is low with an analog connection, switch the ATT (attenuator) control on the Transmitter's rear panel to [0 dB]. Source Equipment with a low output level such as televisions and portable equipment A DTS compatible DVD player is necessary to play DVD discs recorded in DTS. (Refer to your DVD player's operating instructions for further details. ) · There may be some noise emitted during functions such as rewinding and fast forwarding with a DTS format DVD. [. . . ] The chapter being played is not DOLBY DIGITAL format. To clean this unit, wipe with a soft, dry cloth. Specifications are subject to change without notice. Never use alcohol, paint thinner, or benzine to clean this unit. [. . . ]