User manual PANASONIC RX-CT65

[. . . ] · DISPOSE OF BATTERIES IN AN ENVIRONMENTALLY FRIENDLY MANNER. WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PRODUCT DAMAGE, DO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE, DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS. This product may receive radio interference caused by mobile telephones during use. If such interference is apparent, please increase separation between the product and the mobile telephone. THIS UNIT IS INTENDED FOR USE IN TROPICAL CLIMATES. The speakers do not have magnetic shielding. Do not place the unit near televisions, personal computers or other devices easily influenced by magnetism. The socket outlet shall be installed near the equipment and easily accessible or the mains plug or an appliance coupler shall remain readily operable. 2 RQT7611 Control guide RX-CT65 1 2 3 4 5 6 7 8 9 10 11 12 13 14 RX-CT60 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 21 26 28 27 29 30 15 31 16 17 18 19 20 21 22 18 19 20 21 22 32 33 34 35 36 37 Speakers (woofer) Speakers (tweeter) Built-in microphone (MIC) Preset equalizer buttons Band selector (BAND) RX-CT65 Operation/battery check/deck 2 tape direction indicators (OPERATION/BATT, REV, FWD) RX-CT60 Operation/battery indicator (OPERATION/BATT) Editing speed/FM mode/beat proof selector (EDIT/FM MODE/BP) Fine tuning control (FINE TUNING) Function selector (SELECTOR) Tuning control (TUNING) Volume control (VOLUME) Audio input terminal (CD/LINE IN) Headphones jack (PHONES) Deck 2 cassette holder (DECK 2) XBS adjustor (XBS) Deck 1 cassette holder (DECK 1) Recording button ( REC) Playback button ( PLAY) Rewind/review button ( REW/REV) Fast forward/cue button ( FF/CUE) Stop/eject button ( STOP/EJECT) Pause button ( PAUSE) RX-CT65 only Direction button ( DIRECTION) Playback button ( PLAY) Rewind/fast forward buttons ( FAST, FAST) Reverse mode button ( REV MODE) Speakers (super tweeter) Speaker release levers (RELEASE) Speaker terminals (SPEAKERS) Audio input level switch (CD/LINE IN) Whip antenna Speaker cord compartments Speaker cords DC input jack (DC IN) AC socket (AC IN~) Voltage selector (VOLT ADJ) Battery compartment cover 3 RQT7611 Speaker connection A Connect the speaker cords B Attaching the speakers C Detaching the speakers RELEASE RELEASE RX-CT65 2 RX-CT60 1 Before attaching or detaching the speakers, Be sure to disconnect the speaker cords. Be sure to set [SELECTOR] to "TAPE/ OPR OFF ". [. . . ] Reference: Radio broadcasts may be hard to receive in a moving vehicle or building because their signals are weak. Whenever possible, use the unit by a window. Fine tuning control For short-wave broadcasts (SW1, SW2), tune to the approximate frequency with [TUNING], and then use [FINE TUNING] control for more precise tuning. Note When using [TUNING], be sure to set [FINE TUNING] control pointer to the center position. 6 RQT7611 Tapes RX-CT65 RX-CT60 32 1 SELECTOR CD/ LINE IN RADIO TAPE/ 32 3 2 1 SELECTOR CD/ LINE IN RADIO TAPE/ OPERATION/BATT OPERATION/BATT Use normal position/TYPE I tape only. Tape can be played either DECK 1 or DECK 2. Follow steps 1 to 3. In step 1: Set to "TAPE/ OPR OFF ". In step 2: Insert the tape with the side to be played facing out ( ) and close by hand. · Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism. · Tape slack can get caught up in the mechanism and should be taken up before playing the tape. · Endless tapes can get caught up in the mechanism if used incorrectly. "OPERATION/BATT" indicator(s) RX-CT65 DECK 1: Lights while tape is travelling. DECK 2: Shows the selected play side. RX-CT60 Lights while the tape is travelling. To stop play Press [ STOP/EJECT]. To pause play Press [ PAUSE]. Press once again to resume play. To fast-forward or rewind (while stopped) Press [ Press [ end. Press [ REW/REV] (or [ FAST]) or [ FF/CUE] (or [ FAST]). RX-CT65 only STOP/EJECT] to release the button when the tape reaches the To cue or review (during play) REW/REV] or [ FF/CUE]. To play relay (DECK 2 to DECK 1) When Deck 2 play has finished, Deck 1 play starts automatically. Insert the tapes into Deck 1 and Deck 2. RX-CT65 only Set Deck 2 [REV MODE] to " ". Press Deck 1 [ PAUSE], then press [ PLAY]. RX-CT65 only To select the appropriate reverse mode Press [ REV MODE]. STOP/EJECT] is pressed. :Both sides are played repeatedly until [ :Both sides are played once. To select the play side Press [ DIRECTION]. Caution Sound quality may be effected and the cassette tape may become stuck if you do not adhere to the following. · Do not use other stickers not included with the cassette tape. · Place stickers on the cassette tape only as indicated. 7 RQT7611 Recording the radio A Erasure prevention 3 2 1 TUNING Side A Tab for Side A Tab for Side B EDIT/FM MODE/BP HIGH/ STEREO/II NORMAL/ STEREO/II MIC/ MONO/I Use normal position/TYPE I tape only. Follow steps 1 to 3. In step 1: Set [SELECTOR] to "RADIO" and tune to the station. ( page 6) In step 2: Insert the tape inside with the side to be recorded facing out and close by hand. In step 3: [ PLAY] is also depressed with [ REC]. Recording stops and the button is released when the front side finishes. To stop recording Press [ STOP/EJECT]. To pause recording Press [ PAUSE]. To resume recording, press [ PAUSE] again. Recording tips · Changes to volume and tone will not affect the recording. [. . . ] Back cover If the erasure prevention tabs have been removed, cover the holes with adhesive tape. Set the [CD/LINE IN] switch on the rear panel of this unit to HIGH and try recording again. Use the AC power supply cord or insert fresh batteries, and press [ [ STOP/EJECT]. PLAY], then press Not ejected or closed. 11 RQT7611 Maintenance If the surfaces are dirty To clean this unit, wipe with a soft, dry cloth. [. . . ]