User manual PANASONIC RX-ES27P

[. . . ] Portable Stereo CD System Operating Instructions Model No. RX-ES27 Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference. PC RQT6274-C RQT6274-C (Cover-3)En3 1 12/13/01, 4:03 PM Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. The model number and serial number of this product can be found on either the back or the bottom of the unit. [. . . ] Start auto-tuning again if this occurs. ) To stop auto-tuning Press [REW / ­ / Q] or [R / + / FF]. D s To improve reception FM: Change the length and direction of the antenna. Note · AM reception is briefly interrupted if [0 DECK] is pressed. · To improve reception when using the unit in a building or vehicle, use it near a window. To receive FM broadcasts allocated in 0. 1MHz Main unit only First press [TUNER BAND] to select "AM". The display changes in a few seconds to show the current lowest FM frequency. The minimum frequency changes and the step is changed at the same time. Changing the step erases all preset stations. Repeat the above to change the step back. 12/13/01, 4:04 PM A 212 7 7·7 The Radio Preparation: (when using batteries) Press [ POWER /I ]. Preset tuning Tuning is simpler if you preset stations. You can preset 12 FM and 12 AM stations. A SLEEP TIMER FADER DISPLAY Presetting radio stations B 7 Preset channel C 7 1 7 2 7 PRESET EQ TAPE TUNER CD TUNER S. VIRTUALIZER REW FF AUTO SCAN PRESET TUNE CD SKIP ­ VOLUME + 12 7·7 Indicates preset scan PRESET TUNE CD SKIP PRESET TUNE CD SKIP RQT6274-C (9-14)En2 9 1 7 2 7 2 7 1 4 7 2 5 8 3 6 9 PGM/-CLEAR 10 0 1 7 Preparation: Tune to the station you want to preset. (\ page 8) 1 s Press [·MEMORY CLEAR]. 2 s Turn [TIME/PRESET TUNE * While " " is flashing On the remote control Press the numbered button(s) to enter the station into a channel (1 to 12). To enter channel 10, 11 or 12 Press [10], then the two digits. If " " goes off during presetting, return to step s . 1 Selecting channels Preparation: Press [TUNER BAND] to select "FM" or "AM". B s Turn [TIME/PRESET TUNE the channel. CD SKIP ] to select On the remote control Press the numbered button(s) to select the channel (1 to 12). To select channel 10, 11 or 12, press [10], then the two digits. C Using preset scan You can search for a station by listening to all preset channels for 8 seconds each. Remote control only Preparation: Press [TUNER] to select "FM" or "AM". 1 appears on the [ S s Press and holddisplay. / 4 ] or [ 3 / T ] until "PS" Preset scan starts. 2 sired [ S / s Presschannel. 4 ] or [ 3 / T ] when you find the dePreset scan ends after searching through each preset channel once. To stop during the process, press [ S / 4] or [3 / T ]. 3 Cancelling a preset channel 1 2 3 4 e. g. If channel 3 is not needed Select channel 3. While " " is flashing CD SKIP ] to display "­ ­". [. . . ] of channels Wow and flutter D/A converter 44. 1 kHz 16 bit linear Semiconductor laser (wavelength 780 nm) 2 channel, stereo Below measurable limit MASH (1 bit DAC) Tape recorder Track system Monitor system Recording system Erasing system Frequency range Normal position 4 track, 2 channel, stereo Variable sound monitor AC bias Multi Pole magnet 50 Hz ­ 14000 Hz Product information For product information or assistance with product operation: Contact Panasonic Canada Inc. Customer Care Centre at 905-624-5505, web site (www. panasonic. ca), or an authorized Servicentre closest to you. General Speakers Jacks Output Power requirement AC 8 cm 5. 4 x 2 PHONES: 3. 5 mm stereo (16 ­ 32 ) 120 V, 60 Hz Power consumption: 32 W Battery 12 V [Eight R20/LR20 (D, UM-1) batteries] ·Do not use rechargeable type batteries. Memory back-up for computer/clock 6 V [Four R6/LR6 (AA, UM-3) batteries] ·Do not use rechargeable type batteries. Dimensions (W x H x D) 529 x 144 x 276 mm (2013/16 x 511/32 x 107/8 ) Mass 4. 5 kg (9 lb. [. . . ]