User manual PANASONIC S100MA1E5

[. . . ] Indoor Unit Outdoor Unit S-45MA1E5 S-56MA1E5 S-63MA1E5 S-71MA1E5 S-90MA1E5 * S-100MA1E5 * S-125MA1E5 U-4LA1E5 U-5LA1E5 U-6LA1E5 U-4LA1E5-1 U-5LA1E5-1 U-6LA1E5-1 * U-8EA1E8 * U-10EA1E U-10EA1E8 2 ~ 13 14 ~ 25 26 ~ 37 ENGLISH Before operating the unit, read these operating instructions thoroughly and keep them for future reference. P07-T10850-01 00_P07-T10850-01-OYYF1006-00_Cov1 1 30-Jul-10 10:58:02 AM Thank you for purchasing Panasonic Air Conditioner TABLE OF CONTENTS SAFETY PRECAUTIONS 2~3 INFORMATION 4 MULTI AIR CONDITIONER FUNCTION SAFETY PRECAUTIONS To prevent personal injury, injury to others, or property damage, please comply with the following. Incorrect operation due to failure to follow instructions below may cause harm or damage, the seriousness of which is classified as below: WARNING This sign warns of death or serious injury. cAUTION This sign warns of injury or damage to property. [. . . ] Press and hold until you hear 2 beeps then release. Mode Auto Cooling Heating Air inlet INDICATOR POWER TIMER FILTER Control Panel (CZ-RWRM1) (Green) (Orange) (Orange) POWER TIMER FILTER AUTO Transmitter Maximum distances: 8m Remote control display Remote Control Preparation EED MODE MODE AU TO AIR SW ING FA N SP AU TO ADDR ESS 1 2 3 Press and pull out Insert AAA or R03 batteries (can be used ~ 1 year) Press CLOCK 4 Set time 5 Confirm 6 Close the cover TIMER ON OFF/O N MODE AUTO AIR S WING FILTER RE SET FAN SP EED MANU AL SELECT 3 CLOCK TIME R RC RE SET ADDR ESS SET SET CANCEL 4 5 AC RE SET 2 6 1 6 CZ-RWS1 (Heat Pump Model) CZ-RWC1 (Cooling Model) P07-T10850-01_Book 1. Indb 6 30-Jul-10 10:05:43 AM POWER • To turn ON or OFF the unit at a preset time. TO SELECT OPERATION MODE • To cancel ON or OFF timer, press AUTO mode - For your convenience • Unit selects operation mode according to temperature setting, outdoor and room temperature. HEAT mode - To enjoy warm air • Unit takes a while to warm up. FAN mode - To enables air circulation in the room COOL mode - To enjoy cool air DRY mode - To dehumidify the environment • Unit operates at low fan speed to give a gentle cooling operation. €¢ During soft dry operation, the indoor fan operates at a low fan speed. FAN SPEED • When ON timer is set, the unit may start early before the actual set time in order to achieve the desired temperature on time. €¢ Timer operation is based on the clock set in the remote control and repeats daily once set. for clock setting , please refer to Remote Control preparation. €¢ The timer closest to the current time will be activated first. €¢ If timer is cancelled manually, you can restore the previous setting by pressing SET . €¢ If the main power is switched off for an hour or more, the clock and timer will need to be set again. TO SELECT FAN SPEED (3 OPTIONS) AUTO LOW MEDIUM HIGH OPTIONAL SETTINGS • To avoid unintentional operation, you can assign a different address to each indoor unit. €¢ Press repeatedly to select your desired address setting. Group ADDRESS • For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. €¢ If the operation mode is set to Fan, the fan speed will be fixed at MEDIUM regardless of the temperature setting. address 1 Address 2 Address 3 • By default , ADDRESS 1 is selected. You do not need to change this setting for normal operation. €¢ If the address is set to GROUP, more than one indoor unit can be operated at the same time. RC RESET SET AC RESET HINT • Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode. Indb 8 30-Jul-10 10:05:45 AM TO TURN ON OR OFF THE UNIT • To turn ON or OFF the unit at a preset time. [. . . ] €¢ This is due to changes inflow of refrigerant gas when operation stops and starts. • Discharging heat is in process. Operation will stops automatically after approximately 60 seconds. €¢ The unit is in defrosting mode, and the melted frost is drained from the outdoor unit. [. . . ]