User manual PANASONIC S200PE1E8A

[. . . ] Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. Do not install this air conditioner where there are fumes or flammable gases, or in an extremely humid space such as a greenhouse. Do not install the air conditioner where excessively high heat-generating objects are placed. Avoid: To protect the air conditioner from heavy corrosion, avoid installing the outdoor unit where salty sea water can splash directly onto it or in sulphurous air near a spa. [. . . ] Do not cool or heat the room too much if babies or invalids are present. Do not stick any object into the FAN CASE. You may be injured and the unit may be damaged. NOTICE • • The compressor may occasionally stop during thunderstorms. The unit automatically recovers after a few minutes. The English text is the original instructions. Other languages are translation of the original instructions. Names of Parts INDOOR UNIT High static pressure ducted Air intake side duct flange (rear) Water drain Air outlet side duct flange (2 locations) Electrical box Anchor hole Air intake (rear, left side) Air discharge OUTDOOR UNIT Water outlet 4 OI-100-4-EN 01_85464609250020_EN. Fm Page 5 Tuesday, December 11, 2012 7:12 PM Wireless Remote Control Unit (Optional parts) NOTE Refer to the Instruction Manual attached to the optional Wireless Remote Control Unit. (Wireless type: available for all indoor units) Timer Remote Control Unit (Optional parts) NOTE Refer to the Instruction Manual attached to the optional Timer Remote Control Unit. (Wired type: available for all indoor units) Operation Condition Use this air conditioner under the following temperature range. indoor temperature range: Cooling mode 14°C-23°C (*WBT) Heating mode - to 30°C (*DBT) Outdoor temperature range: Cooling mode -15°C-43°C (*DBT) Heating mode -20°C-15°C (*WBT) *DBT: Dry bulb temperature *WBT: Wet bulb temperature OI-100-5-EN 5 01_85464609250020_EN. Fm Page 6 Tuesday, December 11, 2012 7:12 PM Special Remarks ‘‘DRY’’ Operation How it works • • • • Once the room temperature reaches the level that was set, the unit repeats the cycle of turning on and off automatically. In order to prevent the humidity in the room from rising again, the indoor fan also turns off when the unit stops operating. The fan speed is set to ‘‘LO. ’’ automatically , and cannot be adjusted. €˜â€˜DRY’’ operation is not possible if the outdoor temperature is 15°C or less. Heating Operation Heating performance • Because this appliance heats a room by utilizing the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low. If sufficient heat cannot be obtained with this heat pump, use another heating appliance in conjunction with this unit. When the outdoor temperature is low, frost or ice may form on the outdoor heat exchanger coil, reducing the heating performance. when this happens , a microcomputer-controlled defrosting system operates. At the same time, the fan on the indoor unit stops (or runs at very low speed in some cases) and the ‘‘STANDBY’’ indicator appears on the display until defrosting is completed. [. . . ] Always try to keep the air filter clean. (Refer to “Care and Cleaning”. ) A clogged filter will impair the performance of the unit. To prevent conditioned air from escaping, keep windows, doors and any other openings closed. [. . . ]