User manual PANASONIC S224ME1E5A

[. . . ] Indoor Units High Static Pressure Ducted (E1 type) S-224ME1E5A Operating Instructions Air Conditioner 3WAY (MF1 type) U-8MF1E8 U-10MF1E8 U-12MF1E8 U-14MF1E8 U-16MF1E8 (MF2 type) U-8MF2E8 U-10MF2E8 U-12MF2E8 U-14MF2E8 U-16MF2E8 Outdoor Units 2WAY (ME1 type) U-8ME1E81 U-10ME1E81 U-12ME1E81 U-14ME1E81 U-16ME1E81 U-18ME1E81 U-20ME1E81 ENGLISH 2 ~ 10 Before operating the unit, read these operating instructions thoroughly and keep them for future reference. 83 PRODUCT INFORMATION If you have problems or questions concerning your Air Conditioner, you will need the following information. Model and serial numbers are on the nameplate on the bottom of the cabinet. _______________________ Date of purchase ______________________________________________________________ Dealer’s address ______________________________________________________________ Phone number________________________________________________________________ SAFETY PRECAUTIONS The following symbols used in this manual, alert you to potentially dangerous conditions to users, service personnel or the appliance: This symbol refers to a hazard or unsafe practice which can result in severe personal injury or death. [. . . ] - Burnt odor or abnormal noise is detected during operation. - The body is deformed or abnormally hot. Contact immediately your local dealer for maintenance/repair. IMPORTANT INFORMATION REGARDING THE REFRIGERANT USED This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. Refrigerant type: R410A GWP(1) value: 1975 (1) GWP = global warming potential Periodical inspections for refrigerant leaks may be required depending on European or local legislation. Please contact your local dealer for more information. Fm Page 6 Thursday, January 31, 2013 11:24 AM INFORMATION Operation Condition Use this air conditioner under the following temperature range. Outdoor Unit Cooling mode 2WAY (ME1 type) Heating mode Cooling mode 3WAY (MF1 type) Heating mode Cooling & heating mode Cooling mode 3WAY (MF2 type) Heating mode Cooling & heating mode *DBT: Dry bulb temperature *WBT: Wet bulb temperature Indoor 14°C ~ 25°C (*WBT) 16°C ~ 30°C (*DBT) 14°C ~ 25°C (*WBT) 15°C ~ 30°C (*DBT) – 14°C ~ 25°C (*WBT) 15°C ~ 30°C (*DBT) – Outdoor -10°C ~ 43°C (*DBT) -25°C ~ 15°C (*DBT) -10°C ~ 43°C (*DBT) -20°C ~ 15°C (*WBT) -10°C ~ 24°C (*DBT) -10°C ~ 46°C (*DBT) -20°C ~ 18°C (*WBT) -10°C ~ 24°C (*DBT) Information for Users on Collection and Disposal of Old Equipment and Used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. Fm Page 7 Thursday, January 31, 2013 11:24 AM OPERATION Names of Parts INDOOR UNIT E1 Type (HIGH STATIC PRESSURE DUCTED) Air intake side duct flange (rear) Water drain Air outlet side duct flange (2 locations) Electrical box Wireless Remote Controller (Optional parts) NOTE (Wireless type: available for all indoor units) Refer to the Operating Instructions attached to the optional Wireless Remote Controller. Timer Remote Controller (Optional parts) NOTE (Wired type: available for all indoor units) Refer to the Operating Instructions attached to the optional Timer Remote Controller. Fm Page 8 Thursday, January 31, 2013 11:24 AM SPECIAL REMARKS ‘‘DRY’’ Operation How it works • • • • Once the room temperature reaches the level that was set, the unit repeats the cycle of turning on and off automatically. In order to prevent the humidity in the room from rising again, the indoor fan also turns off when the unit stops operating. The fan speed is set to ‘‘LO. [. . . ] If your air conditioner still does not work properly although you checked the points as described above, first stop the operation and turn off the power switch. Then contact your dealer and report the serial number and symptom. Never repair your air conditioner by yourself since it is very dangerous for you to do so. You also report if the inspection mark and the letters E, F, H, L, P in combination with the numbers appear on the LCD of the remote control unit. [. . . ]