User manual PANASONIC S-60PF1E5A

[. . . ] INDOOR UNIT Low Silhouette Ducted (F1 type) Ceiling (T2 type) 4-Way Cassette (U1 type) 4-Way Cassette (U1 type) S-36PU1E5A S-45PU1E5A S-50PU1E5A S-60PU1E5A S-71PU1E5A S-100PU1E5A S-125PU1E5A S-140PU1E5A S-71PT2E5A S-100PT2E5A S-125PT2E5A S-140PT2E5A S-71PF1E5A S-100PF1E5A S-125PF1E5A S-140PF1E5A ENGLISH Before operating the unit, read these operating instructions thoroughly and keep them for future reference. Indb 1 2014/02/28 9:30:58 Thank you for purchasing this Panasonic product. Using of refrigerant other than the specified type may cause product damage, burst and injury etc. This air conditioner has no ventilator for intaking fresh air from outdoors. [. . . ] ς Operation Preparation Turn the power mains on 5 hours before the start of operation. (For warm-up) Leave the power mains ON for continuous use. ς ON NOTE Pull off the power plug from a receptacle, or switch off the breaker, or switch off the power disconnecting mean to isolate the air conditioner from the main power supply when not in use for a long time. For business users in the European Union If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] These symbols are only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Note for the battery symbol (bottom two symbol examples): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. CZ-RTC2 For all indoor units T2 type (Ceiling) Air outlet duct * Bolt anchor * Suspension bolt * High-spec Wired Remote Controller Indoor unit Model No. CZ-RTC3 For all indoor units Ceiling material * Air-outlet grille * * Field supplied F1 type (Low Silhouette Ducted) Read the operating instructions included with the Remote Controller. Operation Mechanism  Heating performance Since this air conditioner utilizes outside air for heating,  its heating performance deteriorates as outside temperature decreases. (Due to heat pump system) →In that case, use another heating appliance. This  appliance may start defrosting operation to melt frost formed in the outdoor unit. π efrosting starts: The indoor unit fan stops (or the D speed becomes extremely slow). →” ” (STANDBY) appears. π eating operation resumes after several H minutes: The indoor unit fan remains stopped (or it will run at a very slow speed) until the indoor heat exchanger coil warms up sufficiently. → ” ” (STANDBY) is shown. πDefrosting is complete: The indoor unit fan starts operation. → ” ” (STANDBY) disappears. ς ‘‘DRY’’ operation  Defrosting Once the room temperature reaches the level that was  set, the outdoor unit repeats the cycle of turning on and off automatically. When the outdoor unit is turned off, the indoor unit fan  will stop, too. (To prevent the humidity in the room from rising again) When the room temperature is more likely to reach the  level that was set, the fan speed is set to ‘‘breeze’’ (light wind) automatically. [. . . ] The fan is rotating for a while even though operation stops. • Fan rotation makes operation smooth. € The fan may rotate to dry the heat exchanger depending on the setting. € When air discharge temperature is low during heating operation, or during defrost operation, horizontal wind flow is made automatically. [. . . ]