User manual PANASONIC S-710WX2E5

[. . . ] INSTRUCTION MANUAL Gas Heat Pump Chiller Water Heat Exchanger M1 Type S-250WX2E5 SGP-WE80M1 S-500WX2E5 SGP-WE170M1 S-710WX2E5 CONTENTS . . . . . . CHARACTERISTICS AND REQUESTS . . . . . . . . . . . . PERIODICAL INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Appears when the indoor unit fan is stopped or in low fan speed. Appears when the protective device is activated or when an abnormality occurs. Appears when a fan available in the market is installed and is operating. Appears when the engine oil needs to be changed. Appears when the protective device is activated or when an abnormality occurs. Indicates the unit No. of the selected indoor unit or the unit No. of the indoor/outdoor unit which an abnormality occurs. Appears while in test operation. 8 OPERATION Setting the Present Time 1. Press and hold for more than 2 seconds to enter in the present day and time setting mode. Once you enter in the setting mode, , “ ”(day) and “time” flash. Set “ ” to today’s day of the week. Press *1 to move “ ” (flashing on the display) in the order of : Su → Mo → Tu → . . . . Press to move it in the order of : Su → St → Fr → . . . . *1 3, 4 1, 3, 4 2 While in time setting mode, the temperature setting buttons function as (changing day) button. to change the present “hour” in the range of 0 to 23*2. The “hour” digits light up, and the “minute” digits start flashing. *2 If the clock uses the 12 hours AM/PM setting, the hour is displayed in the range of AM 0 to 11/PM 0 to 11. 4. Press , to change the present “minute” in the range of 0 to 59. The day and time are set and finishes the setting mode. Note • The unit returns to the normal mode if is pressed or there is no operation made for 3 minutes during the setting. In this case, all the settings in progress will be lost. • If the present time is invalid, “– – : – –” is displayed. If the power failure for more than 1 hour occurs, check if the set data of day and time are valid. 9 Weekly Program Function Checking Weekly Timer Set the weekly program assigning a given timer to each day of the week. Maximum of 6 programs a day and 42 programs a week can be set. Select the day and the TIMER number you want to program. Program image diagram Vertical scale indicates the TIMER No. , and horizontal scale indicates the day. button Su Mo Tu We Th Fr Sa 1 2 3 4 5 6 Select a section from the 42 programs. 1. Press to enter the program confirmation mode “ ” and start setting. [. . . ] “This function is not available” indication lights up (for several seconds). Centralized control indication flashes (for several seconds). Contents The clock is not set. When the operation mode is set to AUTO or FAN, this function is not available. The centralized control device is prohibited from starting/stopping the unit or change the temperature setting. 2 3 The sleeping function operation will be cancelled in the following cases: 1: When the unit is operated to stop or change the temperature setting by the other remote control unit or centralized control device. [. . . ]