User manual PANASONIC SA-313

[. . . ] Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5-ampere and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. [. . . ] Sounds assigned to surround back channels become stereo in playback when you connect two surround back speakers to the unit. Dolby Pro Logic is in this mode in the factory setting. This mode produces good effects when you play commercial film titles recorded in the Dolby Digital Surround EX format. This mode is effective on sources containing surround channels only. Sounds assigned to surround back channels become monaural in playback when you connect two surround back speakers to the unit. DIGITAL EX" or " EX" replaces " PL " on the display when you connect one surround back speaker. ·" You can play games with dynamic sounds in this mode. This mode is effective on 2-channel stereo sources. This mode is unavailable when surround and surround back speakers are unconnected (á pages 9, 10, 22 and 23) or when you set them as absent in "Setting speakers and their sizes" (á page 33). MUSIC EX (Dolby Digital EX) GAME NEO:6 CINEMA MUSIC Use this mode when playing movies. Use this mode when playing music. SFC (Sound Field Control) LIVE POP/ROCK VOCAL JAZZ DANCE PARTY DRAMA ACTION SPORTS MUSICAL GAME Imparts the reflection and spread of a large concert hall. Best suited for dynamic sound such as pop and rock music. Press [SPEAKERS A] on the unit to switch " A " on. (Press [SPEAKERS A] or [SPEAKERS B] to switch " A on when bi-wire speakers are connected. ) If you select "SPEAKERS B" only, the test signal will not be output. B" 1 Press TEST Adjusting speaker volumes How speakers are displayed AUTO · A test signal is output from one speaker at a time for two seconds in the following order. Speaker L L C C R RS R SBR RS SBL SB LS LS SW SW L: Front left C: Center R: Front right RS : Surround right LS : Surround left SBR : Surround back right SBL : Surround back left SB : Surround back (If you connect one surround back speaker) SW (SUBW ) : Subwoofer (When you connect one surround back speaker) · Speakers not connected (á pages 9, 10, 22 and 23) or set as unconnected in "Setting speakers and their sizes" (á page 33) do not output test signals. VOLUME 2 Press to adjust the volumes of front speakers to the normal listening level. 3 Press C C LEVEL Volume range: - - dB (minimum), -79dB to 0dB (maximum) to select a speaker for adjustment. SBR SB SBL LS LS SUBW SUBW Speaker · Speakers switch in the following order each time you press the button. RS RS (When you connect one surround back speaker) Adjustment range: ­20dB to +10dB Factory setting: 0dB SUBW only: MIN (minimum) 1 to 29 MAX (maximum) Factory setting: 20 4 Press to adjust the volume of the selected speaker. Repeat steps 3 and 4 to adjust the level of each speaker. · Only the adjusted speaker produces the test signal in steps 3 and 4. · Connected speakers start producing the test signal again in the above order 2 seconds after both steps. · Press [TEST, ­AUTO] to stop the test signal. You can adjust the output level while playing sources. You can adjust the level according to your preference by thickening or thinning the ultra bass, for example. Press Adjusting the subwoofer level SUBWOOFER to select a level. · Select "--- " to stop output. Adjustment range: --- (off), MIN (minimum), 5, 10, 15, 20, 25, MAX (maximum) Factory setting: SUBW 20 · Sound can be distorted if you raise the volume while the subwoofer level is high. Reduce the subwoofer level if this occurs. · Adjust the output level by taking steps described in "Adjusting speaker volumes" (above) when you wish to make detailed settings. Note Press Silencing speakers temporarily MUTING · "MUTING IS ON " scrolls across the display while the volume is muted. · Press the button again to cancel the operation. Muting is cancelled when you turn the unit off or adjust the volume. Note Dimming the display light (Dimmer) Press DIMMER · Press the button to dim the display. [. . . ] TIL BRUK UNDER ADVARSEL: FOR Å REDUSERE FAREN FOR BRANN, ELEKTRISK STØT ELLER SKADER PÅ PRODUKTET, MÅ DETTE APPARATET IKKE UTSETTES FOR REGN, FUKTIGHET, VANNDRÅPER ELLER VANNSPRUT. DET MÅ HELLER IKKE PLASSERES GJENSTANDER FYLT MED VANN, SLIK SOM BLOMSTERVASER, OPPÅ APPARATET. CAUTION! Do not place anything on top of this unit or block the heat radiation vents in any way. In particular, do not place DVD recorder or CD/DVD players on this unit as heat radiated from it can damage your software. HDMl, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC. [. . . ]