User manual PANASONIC SAP-XRV96EH

[. . . ] (Refer page 7) Auto Restart Control Restart the unit automatically after power failure. (Refer page 8) Enviromental Friendly (For Refrigerant : R410A Models) Zero ozone depleting potential and low global warming potential by using R410A refrigerant. 1) If the supply cord is damaged or needed to be replaced, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. 2) Remove power plug or disconnect from the main before servicing this appliance. [. . . ] Temperature is not displayed on the remote control during AUTO operation. Heat is obtained from outdoor air to warm up the room. When the outdoor ambient air temperature falls, the heating capacity of the unit might be reduced. When the unit is installed floor mounted, you should set the temperature higher than that of ceiling mounted. COOL ­> 26°C ~ 28°C DRY ­> 1°C ~ 2°C lower than the room temperature COOL ­> 26°C ~ 28°C DRY ­> 1°C ~ 2°C lower than the room temperature HEAT ­> 20°C ~ 24°C Connect the power supply cord to an independent power supply. Operation with 2°C higher than the standard temperature. Operation with 2°C lower than the standard temperature. POWER indicator (green) on the indoor unit will light up. Once the Automatic Operation is selected, the indoor temperature sensor operates automatically to select the desired operation mode with Cooling or Soft Dry. ⷠAfter the operation mode has been selected, the mode does not change. At the beginning of the automatic operation, Heating, Cooling or Soft Dry is automatically selected according to the indoor temperature. Example : Operation starts after 6 hours. 8 hours of sleep shift operation, it will stop automatically. Example : Operation stops after 1 hour and re-starts after another 5 hours. Example : Operation starts after 10 hours, and then stops after another 8 hours. 1 hour 1 hour Then press the Timer Setting Button 2 or 3 to the desired number of hours. (Number of hours which can be set : 1 ~ 12) · 8 hours of sleep shift operation, it will stop automatically. Operation is normal if 15 minutes after the start of operation, the difference between the air intake and outlet vents temperature is:Cooling Model Set the temperature higher or lower than the desired temperature. However, temperature cannot be adjusted in this operation. ⷠThe power indicator on the indoor unit will blink until the operation mode is selected automatically. ⷠTo cancel this operation, press once more. This air conditioner is equipped with a built-in surge protective device. [. . . ] This is the sound of refrigerant flowing inside the air conditioner. ⷠCondensation occurs when the airflow from the air conditioner cools the room. ⷠThis may be a damp smell emitted by the wall, carpet, furniture or clothing in the room. ⷠIn COOL/DRY operation, moisture in the air condenses into water on the cool surface of outdoor unit piping that causes dripping. [. . . ]