User manual PANASONIC SB-T100

[. . . ] Please note them in the space provided below and keep for future reference. Use numbers indicated in parentheses when asking for replacement parts. The included AC power supply cord is for use with this unit only. Although the AC power switch is in the "OFF" position, the unit is not completely disconnected from the mains. [. . . ] attaching a stabilizing wire Nylon clamp Screw for nylon clamp Wire (not included) Ring (not included) Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface must be able to support over 45 kg (99 lb. Fit the stand base onto the stand of the speaker unit. Tighten the screws alternately, and finally tighten them hard. Loosen the two height adjusting bolts , and move the stand base. You can obtain a better sound effect by adjusting the height of the speaker to suit the height of the plasma television, for example. Height adjustment range: 1, 183 mm (MIN) - 1, 428 mm (MAX) Height Tighten the height adjusting bolts alternately, and finally tighten them hard. Do not apply an unreasonable force to the net at the front of the speaker unit. You can carry out assembly work stably by placing the cushions in the packing case beneath each speaker. place the speaker with the net side face downward. ( page 6) Be sure to spread a cloth, for example, on the floor to protect it from damage. When using our SA-XR57 AV control receiver (not included) First make the following settings. Setting the speaker (YES/NO) and its size Speaker to be set Setting item SUBW (subwoofer) YES (Connected) LR (Front) SMALL C (Center) SMALL S (Surround) SMALL SB (Surround back) NONE (Not connected) 1-SPK (When one is connected) 2-SPK (When two are connected) · When connecting one surround back speaker Connect it to the "Left" surround back terminal on the amplifier. When connecting two surround back speakers Connect them to the "Left" and "Right" surround back terminals on the amplifier. Setting the lower region filter Selection frequency: 100 (Frequencies of 100 Hz and below are output to the subwoofer. Connect to a receiver or amplifier with 6- impedance for the front, center, and surround speakers, and a pin-type output terminal for an active subwoofer. You cannot connect these speakers to any equipment other than this amplifier. Do not connect the AC power supply cord until all other cables and cords are connected. Front, center, and surround speakers Connect the front and center speakers with the 4-meter (13. Be sure to connect only positive (copper) wires to positive (+) terminals and negative (silver) wires to negative (­) terminals. Do not move the speaker while the speaker cables are connected. Make sure to bundle the speaker cable with a string etc. [. . . ] The items listed are not exclusive, but are for illustration only. ) ALL EXPRESS AND IMPLIED WARRANTIES , INCLUDING THE WARRANTY OF MERCHANTABILITY , ARE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the exclusions may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. [. . . ]