User manual PANASONIC SB-TP70

[. . . ] DATE OF PURCHASE DEALER NAME DEALER ADDRESS TELEPHONE NUMBER The model number and serial number of this product can be found on either the back or the bottom of the unit. Please note them in the space provided below and keep for future reference. Before connecting, operating or adjusting this product, please read these instructions completely. Please keep this manual for future reference. [. . . ] The speaker may fall off if you loosen the screws too much. After adjusting the speaker height and the length of the cable, securely fasten the two stabilizer attachment screws. 1104-1390 mm (43-15/32 to 54-3/4) Note Do not get the speaker cable caught between the assembled stabilizer and the speaker. fit the speaker cable in the groove in the base. (Indicated above in step 4) Nylon clamp Screw for nylon clamp Wire (not included) Ring (not included) Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface must be able to support over 40 kg (88 lb. Place the rubber pads (included) in four places on the back of the speaker where it contacts the wall, and on the two attachment holes for the assembled stabilizer. Screw (not included) Screw the wood screw into a thick and hard part of the wall. The surface must be able to support over 18 kg (39. Front speaker (Left) (SB-FS70) Center speaker (SB-PC70) Front speaker (Right) (SB-FS70) Surround speaker (Right) (SB-FS70) Surround speaker (Left) (SB-FS70) Active subwoofer (SB-WA70) The front, center, and surround speakers should be placed at approximately the same distance from the listening position. the angles in the diagram are approximate. How you set up your speakers can affect the bass and the sound field. Use spacers or a similar item to stop them from rocking. Placing speakers too close to walls, and corners can result in excessive bass. Cover walls and windows with a thick curtain. Do not place anything on top of the subwoofer. Usage and handling note (SB-FS70): Do not stand on the base and shake the speaker. When excess input is detected, the sound is automatically interrupted. after the protection circuitry is reset. Take care not to increase the receiver's or amplifier's volume level too much. Connect to a receiver or amplifier with 6- impedance for the front, center, and surround speakers, and a pin-type output terminal for an active subwoofer. Do not connect the AC power supply cord until all other cables and cords are connected. [. . . ] If it persists, move the speakers further away from the television. Magnetized cards, bank cards, commuter passes, etc. , can be damaged if allowed too near speaker magnets. Near heating appliances or other sources of heat · Clean these units with a soft, clean, dry cloth. [. . . ]