User manual PANASONIC SBZT2

[. . . ] Operating Instructions Speaker System Model No. If you have any questions contact In the U. S. A. and Puerto Rico: 1-800-211-PANA (7262) In Canada: 1-800-561-5505 For U. S. A. and Puerto Rico only SB-ZT1 SB-ZT2 IMPORTANT SAFETY INSTRUCTIONS Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. [. . . ] Press and hold [CH] on the remote control (SC-ZT2) about 3 seconds until "4 SPKR SET " is displayed on the main unit's display. · Always aim the remote control at the main unit for operation. Press the remote control (SC-ZT2) button corresponding to the speaker outputting the confirmation sound. Speaker ( left page) Front speaker (left) Front speaker (right) Surround speaker (left) Surround speaker (right) Corresponding buttons ( page 15 of SC-ZT2 Operating Instructions) : [GAME] : [MUTE] : [­SETUP, OFF] RETURN] :[ Caution · Use the speakers only with the recommended system. Failure to do so can damage the amplifier and speakers, and can cause fire. Consult a qualified service person if damage occurs or if a sudden change in performance is apparent. · Do not attach these speakers to walls or ceilings. · Sound is output from any of the speakers. · When you press the button corresponding to the confirmation sound of a speaker, another speaker outputs a confirmation sound. Press the corresponding button in the same way and complete settings for all 4 speakers. · When "COMPLETE " disappears on the main unit's display, the speaker setting is complete. Note · Check if the speakers are properly set after setting the speakers. ( page 14 of SC-ZT2 Operating Instructions) · If the speakers are set incorrectly in step 8, turn the main unit (SC-ZT2) off then on again and perform steps 7 and 8. · If the [WIRELESS LINK] indicator does not change from red to green, see page 27 of SC-ZT2 Operating Instructions, "Troubleshooting guide". · When you turn the main unit (SC-ZT2) off with the speakers on, the speakers automatically enter Standby (Wireless Link Standby). The color of the [WIRELESS LINK] indicator turns to red. · To reduce more of the power consumption of speakers in Standby, turn the speakers off. The speakers enter Standby (In Standby condition). <Power consumption of speakers in Standby> Wireless Link Standby: approx. 0. 8 W (per 1 speaker) In Standby condition: approx. 0. 1 W (per 1 speaker) TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PRODUCT DAMAGE, * DO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE, DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS. * DO NOT REMOVE THE COVER (OR BACK); THERE ARE NO USER SERVICEABLE PARTS INSIDE. Damage requiring service -- The unit should be serviced by qualified service personnel if: (a) The AC power supply cord or the plug has been damaged; or (b) Objects or liquids have gotten into the unit; or (c) The unit has been exposed to rain; or (d) The unit does not operate normally or exhibits a marked change in performance; or (e) The unit has been dropped or the cabinet damaged. [. . . ] · Do not use this device as a plaything. FCC Note: THE FOLLOWING APPLIES ONLY IN THE U. S. A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]