User manual PANASONIC SC-NE1

[. . . ] SC-NE1 Thank you for purchasing this product. Please read these instructions carefully before using this product, and save this manual for future use. Customers only) Included Installation Instructions (l 2, 3 and 10, 11) The installation work should be done by a qualified installation specialist. Before commencing work, carefully read these installation instructions and the operating instructions to ensure that installation is performed correctly. [. . . ] Bluetooth® input level If the sound input level of the Bluetooth® transmission is too low, change the input level setting. preparation ≥ Connect a Bluetooth® device. Connecting a paired Bluetooth® device Preparation ≥ Turn on the Bluetooth® feature of the device and place the device near this unit. ‰ If this unit is already connected to a Bluetooth® device, disconnect it. 1 2 Press [PLAY MENU] repeatedly to select “INPUT LEVEL”. Press [3, 4] to select the level and then press [OK]. The name of the connected device is indicated on the display for 2 seconds. Start play on the Bluetooth® device. disconnecting a Bluetooth® device ≥ This unit can only be connected to one device at a time. To return all settings to the factory preset When the following situations occur, reset the memory: ≥ There is no response when buttons are pressed. ‰ You want to clear and reset the memory contents. remote control The remote control doesn't work properly. ‰ The remote control and this unit are using a different code. (l below, “REMOTE  ”) ≥ Is the battery depleted or is the battery inserted incorrectly?(l 5) Messages The following messages or service numbers may appear on the unit's display. €AUTO OFF” ≥ The unit has been left unused for about 30 minutes and will shut down within a minute. (Wait for at least 3 minutes before proceeding to step 2. ) 2 While pressing and holding down [Í/I] on the unit, reconnect the AC power supply cord. ‰ Keep holding down [Í/I] until “--------” appears on the display. ‰ All the settings are returned to the factory preset. You will need to reset the memory items. €DIMMER” ≥ Appears 10 seconds after the volume is turned to “0”. [. . . ] The warranty ALSO DOES NOT COVER damages which occurred in shipment, or failures which are caused by products not supplied by Panasonic Canada Inc. , or failures which result from accidents, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation, set-up adjustments, misadjustment of consumer controls, improper maintenance, power line surge, lightning damage, modification, introduction of sand, humidity or liquids, commercial use such as hotel, office, restaurant, or other business or rental use of the product, or service by anyone other than an Authorized Servicer, or damage that is attributable to acts of God. Dry cell batteries are also excluded from coverage under this warranty. (As examples, this warranty excludes damages for lost time, travel to and from the Authorized Servicer, loss of or damage to media or images, data or other memory or recorded content. [. . . ]