Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PANASONIC SC-PM03. We hope that this PANASONIC SC-PM03 user guide will be useful to you.
Lastmanuals help download the user guide PANASONIC SC-PM03.
You may also download the following manuals related to this product:
PANASONIC SC-PM03 (1121 ko)
Manual abstract: user guide PANASONIC SC-PM03
Detailed instructions for use are in the User's Guide.
[. . . ] Do not spray insecticides onto or into the system. They contain flammable gases which can ignite if sprayed into the system.
Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. [. . . ] DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. The socket outlet shall be installed near the equipment and easily accessible. The mains plug of the power supply cord shall remain readily operable. To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord plug from AC receptacle. This product may receive radio interference caused by mobile telephones during use. If such interference is apparent, please increase separation between the product and the mobile telephone. THIS UNIT IS INTENDED FOR USE IN MODERATE CLIMATES. MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson.
2. Replace the fuse and close or attach the fuse cover. Figure A Figure B
4
A
OVERVIEW OF CONTROLS
SLEEP
PLAY
I J
Refer to the numbers in parentheses for chapter references.
A Standby/on switch [`], [1] (8, 13)
I Set the sleep timer (8)
Set the clock and timer (8)
MUSIC P.
Fuse (5 ampere)
Fuse (5 ampere)
B K C D L
RADIO
EXT-IN
Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still consuming a small amount of power. Press [4/9] to start playback.
2 Press [AUTO PRESET] to start
presetting. To cancel, press [8].
To improve the sound quality
When "FM" is selected 1 Press [RADIO MENU] to select "FM MODE".
1 Press [PROGRAM] in the stop mode. 2 Press [R, T] to select the desired 3 4 5
Manual presetting
30 FM and 15 AM stations can be preset.
INPUT LEVEL "NORMAL" or "HIGH" (For music port source)
D. BASS
This function lets you enjoy a powerful bass effect. Press [D. BASS] to select "ON D. BASS" or "OFF D. BASS".
album. Press [6] and then press the numeric buttons to select the desired track. Do steps 2 through 4 again to program other tracks. Press [2] or [6] when "PGM" is shown in the stop mode. To check while programming, press [PROGRAM] two times after "PGM" is shown, then press [2] or [6]. Press [DEL] in the stop mode.
2 Press [Y, U] to select "MONO" and then
press [OK]. · "MONO" is also cancelled when you change the frequency. · Switch off "MONO" for normal listening.
Preparation Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN]) to select "FM" or "AM". [. . . ] "#PLAY 2" or "#PLAY 3". Press [SLEEP] to select the setting (in 6 Press [`] to switch off the system. The system must be switched off for the To cancel, select "OFF". 60 MIN 90 MIN 120 MIN 30 MIN Change the Do steps 1 through 4 and 6 OFF settings again (Z above).
To set the code to "REMOTE 2" 1 Press and hold [RADIO/EXT-IN] on the main unit and [2] on the remote control until "REMOTE 2" is shown.
To set the code to "REMOTE 1" 1 Press and hold [RADIO/EXT-IN] on the main unit and [1] on the remote control until "REMOTE 1" is shown.
Amplifier section
2 Press and hold [OK] and [2] for a
minimum of 4 seconds.
2 Press and hold [OK] and [1] for a
minimum of 4 seconds.
RMS output power stereo mode USB port Front Ch (both ch driven) USB standard USB 2. 0 full speed 10 W per channel (6 ), 1 kHz, 10% THD Media file format support MP3 ( . mp3) Total RMS stereo mode power 20 W USB device file system FAT 12, FAT 16, FAT 32 USB port power 500 mA (max)
FM tuner, terminals section
12
MAINTENANCE
Preset station
FM 30 stations AM 15 stations
Speaker section
Type 1 way, 1 speaker system (bass reflex) Speaker unit(s) Full range 10 cm cone type Impedance 6 Output sound pressure 83 dB/W (1 m) Frequency range 61 Hz to 17 kHz (16 dB) 95 Hz to 15 kHz (10 dB) Dimensions (W x H x D) 139 mm x 224 mm x 138 mm Mass 1. 3 kg
To clean this system, wipe with a soft, dry cloth. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PANASONIC SC-PM03
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PANASONIC SC-PM03 will begin.