User manual PANASONIC SC-AK310

[. . . ] These operating instructions are applicable to the following system. These operating instructions, however, fundamentally explain the operation of system SC-AK310. Supplied accessories Please check and identify the supplied accessories. AC mains lead . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 pc. For United Kingdom (RJA0044-1C) For Australia and New Zealand (RJA0035-X) Before using System Main unit Speakers SC-AK310 SA-AK28 SB-AK28 SC-AK18 SA-AK18 SB-AK18 Remote control transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] However, do not use irregular shaped CDs. A xx xx xx xx xx xxxxxxx xxxxxxx xx xx xxxx xx xx xxx xx Handling precautions B ~ D · · · · · · If you are taking the disc from a cold to a warm environment, moisture may form on the disc. Wipe this off with a soft, dry, lint-free cloth before using the disc. Do not write on the label side with a ball-point pen or other writing instrument. Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids or any other solvent. Do not attach labels or stickers to CDs. (Do not use CDs with exposed adhesive from tape or left over peeled off stickers. ) Do not use scratch-proof protectors or covers other than those specified for use with this system. Do not use CDs printed with label printers available on the market. Storage precautions Be sure to store discs in their cases to protect them from dust, scratches, and warping. Do not place or store discs in the following places · Locations exposed to direct sunlight · Humid or dusty locations · Locations directly exposed to a heat vent or heating appliance · In the glove compartment or on the rear deck of an automobile To prevent damage Always observe the following points. E · Load CDs as shown in figure F The adapter is not needed with 8 cm CDs (singles). · Set the system on a flat, level surface. A All tracks on the loaded CDs are repeated. To cancel repeat play Press [REPEAT] once again. Program the tracks you want (perform steps 1 ~ 6 on page 17). Press [REPEAT] and make sure " " is displayed. To repeat just one track Set the 1-TRACK mode (page 18), press [REPEAT] before or during playback, and make sure " " is displayed. Random play A B Press [RANDOM]. B Every time you press the button: 1-DISC ALL-DISC Previous display To random play just one disc Select the CD you want to random play with [(CD 1) ~ (CD 5)] and press [RANDOM] to select "1-DISC". To random play all the loaded CDs Press [RANDOM] to select "ALL-DISC". All tracks on the CD(s) will be played in random order. Playback will stop automatically when all tracks have been played. To cancel random play Press [RANDOM] to clear "RANDOM" display. Note You can use random play with your program. Only the programmed tracks will be played, but in random order. 16 RQT5265 Listening to compact discs Program play by remote control only You can program up to 24 tracks. 4 2 1 3 5 1 Press [CD]. Ensure CD is stopped. 7 2 3 Press [PROGRAM]. [. . . ] The wiring at the back of the system is unsuitable. If you are using an indoor antenna, change to an outdoor antenna. Separate the antenna wire of the TV set from the system. 7 While using the cassette deck Sound is low, intermittent, poor quality, noisy, scratchy, or unsteady. [. . . ]