User manual PANASONIC SC-CH530

[. . . ] These operating instructions are applicable to the following system. Table of contents IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . 3 Listening caution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Supplied accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 The remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1 Press [PROGRAM] then press [g/REW/3 ] [4/ FF/f] to tune to the desired station. 2 Press [PROGRAM] then press [g/REW/3 ] [4/ FF/f] to select a channel. or or Hold down [PLAY MODE] to display "MONO". Monaural sound is selected and noise reduces when reception is weak. Hold down [PLAY MODE] again to cancel the mode. "MONO" is also cancelled if the frequency is changed. To receive FM broadcasts allocated in 0. 1MHz steps Main unit only Hold down [TUNER/BAND]. The display changes in a few seconds to show the current minimum FM frequency. Continue to hold down the button until the minimum frequency changes. Changing the step erases all preset stations. Repeat the above to change the step back. Notes · After changing the "allocation" setting, the frequencies you previously preset in the memory will be cleared. · Sound is momentarily interrupted if you load/unload tapes while listening to an AM broadcast. The station occupying a channel is erased if another station is preset in that channel. Selecting channels Press the numbered buttons to select the channel. To enter channel 10 or over, press [10], then the two digits. · Always stop the changer before loading or changing CDs. You cannot change CDs while a disc is playing. · CD display You can display the remaining play time of the current track. Press [DISPLAY] during play or pause. Every time you press the button: Elapsed play time Remaining play time Note When track number 25 or greater is playing, remaining play time display shows "­ ­:­ ­". 1· 2 PLAY MODE 1· 2 2· 3 1 4 2 2 1 4 3 Starting play from a specific track Remote control only To listen to specific CDs and tracks (CD Play Mode function) Remote control only Preparation: Press [CD :/ J] and then [L]. 1 Press [DISC] and (within 10 seconds) [1]­[5] to select the disc. 2 Select the track with the numbered buttons. To select track 10 or over, press [10] then the two digits. Note You cannot use this function with 1-RANDOM or A-RANDOM mode. 1 Press [PLAY MODE] to select the desired mode. Every time you press the button: ALL-DISC 1-SONG 1-RANDOM 1-DISC A-RANDOM ALL-DISC: Program play You can program up to 24 tracks. Remote control only Preparation: Press [CD :/ J and then [L]. J] Plays all loaded discs in succession from the selected disc to the final disc . 1-SONG: Plays one selected track on the selected disc. 1-RANDOM: Plays one selected disc in random order. A-RANDOM: Plays all loaded discs in random order. (The original display is restored in about 2 seconds. ) 1 Press [PROGRAM]. "PGM" appears. Proceed to step 4 when you selected A-RANDOM in step 1. 2 Press [DISC] and (within 10 seconds) [1]­[5] to select the disc. The CD starts play if in ALL-DISC, 1-RANDOM or 1-DISC mode. 2 Press [DISC] and (within 10 seconds) [1]­[5] to select the disc. 3 Select the tracks with the numbered buttons. To select track 10 or over, press [10] then the two digits. Repeat steps 2 and 3 to program other tracks. 3 Only when you selected "1-SONG" in step 1 Press [g/REW/3] or [4/FF/f] to select the track. 4 Press [CD :/ J] to start play. To exit program mode Press [PROGRAM] in the stop mode. (You can replay your program by pressing [PROGRAM] then [CD :/ J]. ) To cancel Press [L] in the stop mode. To check program contents Press [g/REW/3] or [4/FF/f] while "P" is displayed. [. . . ] 9. 5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985 Panasonic/Technics Audio Products Limited Warranty Panasonic Consumer Electronics Company or Panasonic Sales Company (collectively referred to as "the Warrantor") will repair or replace this product with new or refurbished parts or equivalent product, free of charge in the U. S. A. or Puerto Rico, in the event of a defect in materials or workmanship as follows (all time periods commence from the date of original purchase): AUDIO PRODUCTS--labor and parts for one (1) year. ALL AUDIO RACKS (cabinets)--parts only 30 days. TECHNICS STAND ALONE SPEAKERS, SUBWOOFER SPEAKERS--labor and parts for three (3) years. [. . . ]