User manual PANASONIC SCHTB10EB

[. . . ] Operating Instructions Home Theater Audio System Model No. SC-HTB10 Dear customer Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. Before connecting, operating or adjusting this product, please read the instructions completely. [. . . ] When the delay information cannot be retrieved, the audio delay is set to 40 ms. 14 Specifications GENERAL Power consumption: 30 W Power consumption in standby mode: Approx. 0. 2 W Power supply: AC 220 V to 240 V, 50 Hz Dimensions (WkHkD): (Without wall mount bracket) 800 mmk108 mmk58 mm (With wall mount bracket) 800 mmk108 mmk80 mm Mass: (Without wall mount bracket) Approx. 3. 2 kg (With wall mount bracket) Approx. 3. 3 kg Operating temperature range: 0 oC to r40 oC Operating humidity range: 20 % to 80 % RH (no condensation) SPEAKER SECTION FRONT SPEAKERS (BUILT-IN) Type: 1 way, 1 speaker system (Bass Reflex) Full range: 6. 5 cm Cone typek2 SUBWOOFER (BUILT-IN) Type: 1 way, 1 speaker system (Bass Reflex)k2 Woofer: 8 cm Cone typek2 TERMINAL SECTION HDMI This unit supports "HDAVI Control 5" function. HDMI input Input connector: Type A (19 pin) HDMI AV output Output connector: Type A (19 pin) Digital Audio Input (TV only) Optical digital input: Optical terminal Sampling frequency: 32 kHz, 44. 1 kHz, 48 kHz Audio Format: LPCM, Dolby Digital IR Blaster Terminal 1: 3. 5 mm jack 1 Specifications are subject to change without notice. 2 Total harmonic distortion is measured by a digital spectrum analyzer. AMPLIFIER SECTION RMS Output Power Front ch: 30 W per channel (4 ), 1 kHz, 10 % THD Subwoofer ch: 30 W per channel (4 ), 100 Hz, 10 % THD Total RMS Dolby Digital mode power: 120 W Audio information Compatible audio formats This unit is compatible with the following formats: Dolby Digital, DTS Digital Surround, 2-channel LPCM and multi-channel LPCM. When using the optical digital audio cable, this system is not able to play audio with a sampling frequency greater than 48 kHz. (Sound Effect and Dolby Virtual Speaker will be automatically cancelled if the audio signal's sampling frequency is greater than 48 kHz. ) Operating Instructions 15 Troubleshooting Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated in the following guide do not solve the problem, consult your dealer for instructions. General operation To return to the factory preset. While this unit is on, press [Í/I] on this unit for more than 4 sec. (All the indicators will blink twice when the unit is reset. ) The remote control doesn't work properly. It is possible that the insulation sheet has not been removed. ( 7) The remote control and this unit are using different codes. ( 17) It may be necessary to set the code of the remote control again after changing the battery of the remote control. ( 17) This unit does not operate correctly. If the HDMI cable is connected to the wrong terminal (HDMI AV IN or HDMI AV OUT), this unit will not operate correctly. Turn this unit off, disconnect the AC mains lead and reconnect the HDMI cable(s). ( 10) When operating the connected device, this unit reacts in an unwanted manner. HDAVI Control commands may use a different signal depending on the make of the device. In this case, set "VIERA Link" to "Off". ( 17, "VIERA Link") VIERA Link related operations no longer function properly. Check the "VIERA Link" setting on the connected devices. [. . . ] jThe position in the wall where the screw is to be attached should be capable of supporting over 20 kg. 23 Attaching this unit to a wall 6 Thread a cord (not supplied) through the wall mount bracket. Use a cord which is capable of supporting over 20 kg. A Rear of this unit B Fall prevention cord (not supplied) 7 Attach the lock pins into the wall mount bracket. The lock pins are designed to lock the wall mount brackets to the screws that this unit is attached to. Hence, preventing this unit from falling off the screws. Keep the lock pins out of reach of children to prevent swallowing. [. . . ]