User manual PANASONIC SC-PM533

[. . . ] Use numbers indicated in parentheses when asking for replacement parts. Before connecting, operating or adjusting this product, please read the instructions completely. Please keep this manual for future reference. Operations in these instructions are described using remote control, but you can do the operations with the main unit if the controls are the same. [. . . ] You can repeat program play or other selected play mode. High position and metal position tapes can be used, but this unit will not be able to record or erase them correctly. Preparation Wind the leader tape so that recording can begin immediately. The buttons described for "Cassette tape" are mainly for the main unit unless indicated otherwise. To play the other side of the cassette, turn the cassette over. Press [TAPE 3] when the unit is OFF with the cassette loaded. Erase a recorded sound stop recording stop recording temporarily record on the other side of the tape Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism. ⷠEndless tapes can get caught up in the decks moving parts if used incorrectly. You can perform the same operation of [¶ REC¥8] on the main unit by pressing [REC ¶¥8] and [TAPE] simultaneously on the remote control. This function enables you to search the beginning of a track, up to a maximum of 9. press [4/REW/4] or [3/FF/¢] during play. note TPS may not function properly: · With short silent parts · When noise occurs between tunes · To record on the tape again, cover as shown. Up to 15 stations can be set in both the FM and AM bands. Repeat steps 2 to 4 to preset more stations. For channels 10 to 15 press [h10], then the two digits. By main unit only This system can also receive FM broadcasts allocated in 0. " ST " is displayed when a stereo FM broadcast is being received. To tune automatically Press [4/REW/4] or [3/FF/¢] for a moment until the frequency starts changing rapidly. The unit begins auto tuning, stopping when it finds a station. ⷠAuto tuning may not function when there is excessive interference. After a few seconds the display changes to a flashing display of the current minimum frequency. When the minimum frequency changes, release the button. [. . . ] This warranty gives you specific legal rights and you may also have other rights which vary from state to state. If a problem with this product develops during or after the warranty period, you may contact your dealer or Servicenter. If the problem is not handled to your satisfaction, then write to the warrantors Consumer Affairs Department at the addresses listed for the warrantor. Parts One (1) year One (1) year Ninety (90) days Ten (10) days Ninety (90) days Labor One (1) year Not Applicable Ninety (90) days Not Applicable Not Applicable During the "Labor" warranty period there will be no charge for labor. [. . . ]