User manual PANASONIC SCSP100EG

[. . . ] They contain flammable gases which can ignite if sprayed into the unit. This can overload the unit and cause a fire. Check the source carefully when setting the unit up on a ship or other places where DC is used. Do not attempt to repair this unit by yourself. [. . . ] Dispose of used batteries according to the manufacturer's instructions. Compatibility depends on the software version of your iPod or iPhone. If you are not using the iPod or iPhone for an extended period of time after recharging has completed, disconnect it from the main unit, as the battery will be depleted naturally. Do not recharge, disassemble, heat above 60°C or incinerate. Rear view AC mains lead (included) Use the adaptor supplied with your iPod or refer to Apple Inc. For the compatible dock adaptor (for details, refer to the instructions supplied with the dock adaptors), which may need to be purchased separately. The AC adaptor (switching power supply) is in the standby condition when the mains plug is connected. The included AC mains lead is for use with this unit only. Do not use an AC mains lead from other equipment. Do not use any other AC adaptors (switching power supplies) except the supplied one. When removing, insert your fingernail or a flat object and lift upwards. You can navigate the iPod or iPhone using the buttons described. The power indicator blinks each time a button on the remote control is pressed. Power indicator Main unit Remote control Function Turn the main unit's power on or off. The power indicator lights up when the main unit is on. The operation switch does not separate entire unit from mains even if in off position. The SURROUND indicator on the main unit button lights up when the surround function is activated. The BASS indicator on the main unit button lights up when the bass function is activated. [. . . ] If you are in doubt about some of the check points, or if the solutions indicated in the table do not solve the problem, consult your dealer for instructions. No power No sound · Update your iPod or iPhone with the latest software. Turn off the iPod or iPhone, remove it from the dock connector. RMS output power stereo mode Front Ch (both channels driven) 5 W per channel (6 ), 1 kHz, 10% THD Subwoofer Ch 10 W per channel (6 ), 100 Hz, 10% THD Total RMS stereo mode power 20 W ENGLISH Front speakers Speaker unit(s) Full range Input power (IEC) Subwoofer Speaker unit(s) Woofer Passive radiator (x2) Input power (IEC) Impedance: 6 4 cm cone type 5 W (Max) Impedance: 6 6. [. . . ]