User manual PANASONIC SC-UA3E

[. . . ] SC-UA4 SC-UA3 Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully. Please keep this manual for future reference. Book Page 2 Wednesday, June 7, 2017 3:28 PM These operating instructions are applicable for models SC-UA3 and SC-UA4. [. . . ] The system is not tuned in to a station. To start the timer Prepare the source you want to listen to (disc, USB or radio) and set the volume. The system must be switched off for the timer to operate. RDS broadcasting This system can show the text data transmitted by the radio data system (RDS) available in some areas. PS PTY FREQ Programme service Programme type Frequency To check the setting Press [SETUP] repeatedly to select “TIMER ADJ” and then press [OK]. in standby mode , press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. € The timer comes on at the set time every day if the timer is on. € If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the end time. Book Page 12 Wednesday, June 7, 2017 3:28 PM Sleep timer The sleep timer switches off the system after the set time. Illumination You can switch on or switch off the illumination on the system. 1 2 Press [SETUP] to select “SLEEP”. Press [R, T] to select the setting (in minutes) and then press [OK]. Note: • The remaining time is shown for a few seconds every minute. €SLEEP 1” is always shown when only 1 minute remains. be sure not to set an overlap of timers. Note: When dimmer function is switched on, the illumination on the system will remain off although you have switch on the illumination function. Jukebox USB Sound effects Preset EQ You can use the jukebox to add a cross-fade effect between songs. You can also use additional features with the “Panasonic MAX Juke” app (Z below). 1 2 Press [SOUND] to select “PRESET EQ”. Press [R, T] to select the desired preset EQ setting and then press [OK]. Press [R, T] to select the setting and then press [OK]. [. . . ] For more information about collection and recycling, please contact your local municipality. Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation. Note for the battery symbol (bottom symbol): This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved. [. . . ]