User manual PANASONIC SH-KS28

[. . . ] 11 Troubleshooting guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Sticker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1pc. AC power supply cord (RJA0065-A) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 1924 · RIES ·A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE SCREWS. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 3 RQT6018 IMPORTANT SAFETY INSTRUCTIONS Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference. 1) 2) 3) 4) 5) 6) 7) Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. A polarized plug has two blades with one wider than the other. It is also possible to mix and monitor the line-out sources. ·The model comes with line-out connectors for monitoring so that sound can be monitored not only with headphones but through the speakers inside the booth. ·The line-out source L and R levels as well as the monitor source levels can be checked out on the 12-point, 3-column level meter. ·An [AUX IN] connector is provided to enable a sampler, keyboard, etc. to become part of the disc jockey scene. 5 RQT6018 Connections Stereo connection cable (white) (L) (red) (R) CH turntable (not included) CH CD or MD player (not included) CH turntable (not included) CH MD or CD player (not included) Grounding wire Grounding wire Rear panel Household AC outlet AC power supply cord (included) ( page 9 ) Monitor amplifier (not included) Speakers Booth monitor Sampler (not included) Alternatively, a keyboard or other unit can be connected. Cassette deck (not included) Amplifier (not included) Speakers Alternatively, a power amplifier, PA system or other unit can be connected. Rear panel connections This model is connected with the other equipment using stereo connection cables (not included). Before proceeding with the connections, make absolutely sure that the power is turned off to the units concerned. Connect the power cord after all the other connections have been completed. For your reference: A grounding wire need not be connected if the turntable does not have a grounding wire or terminal. 6 RQT6018 A Plug type: 6. 3 mm (1/4 in. ) monaural Microphone (not included) Mic input jack Headphones jack Plug type: 6. 3 mm (1/4 in. ) stereo Headphones (not included) B Amplifier Monitor amplifier Turntable 1 Turntable 2 Turntable 3 Turntable 4 CD, MD player 1 MD, CD player 2 CD, MD player 3 MD, CD player 4 LINE OUT AUX IN MONITOR OUT LINE OUT MONITOR OUT Master mixer Sub mixer Front panel connections To listen with the headphones: ·Before connecting headphones, turn down the volume with [MONITOR LEVEL], etc. ·Avoid listening for prolonged periods of time to prevent hearing damage. Connecting two audio mixers side by side Connect the [LINE OUT] connector of the sub mixer to the [AUX IN] connector on the master mixer. How to align the volume levels of the master and sub mixers: Adjust [AUX/EFFECTOR] volume on the master mixer and [MASTER] volume on the sub mixer so the levels are identical. 7 RQT6018 Names of the parts MASTER TRIM OUTPUT LEVEL POWER LEFT MONITOR +8 MIN MAX MIN MAX MONITOR TRIM LEVEL RIGHT +8 +5 +3 +1 0 -1 -3 -5 -7 -10 -15 -20 dB -24dB +12dB -24dB +12dB MASTER CUE MIN MAX MIN MAX +5 +3 +1 0 -1 -3 -5 -7 -10 -15 -20 dB AUX/EFFECTOR HIGH HIGH BALANCE MIN MAX -24dB +12dB MIC LOW LOW CUE A B MIN MAX -24dB +12dB INPUT PHONO PHONE LINE LINE PHONO PHONE BOOTH/PHONES INPUT INPUT A B 10 9 8 7 6 5 4 3 2 1 0 10 9 8 7 6 5 4 3 2 1 0 Front panel Rear panel 8 RQT6018 ( ( ( ) Channel fader (INPUT) ) Input selector (LINE, PHONO) ) LOW-range level control (LOW) [MONITOR BALANCE] control Select [CUE] (completely to the right) ·Works as past general DJ mixer monitors. ·Allows the CH ( , ) input selected with [MONITOR CUE] to be monitored regardless of the position of the [INPUT] channel faders and [CROSS FADER]. MIC volume level control (MIC) AUX/EFFECTOR volume level control (AUX/EFFECTOR) MASTER volume level control (MASTER) ( ( ) Input sensitivity control (TRIM) ) HIGH-range level control (HIGH) Select [MASTER] (completely to the left) ·Disregards the source selected with [MONITOR CUE] ( , ). ·Allows monitoring of the output from the [LINE OUT] connector . OUTPUT LEVEL meter (OUTPUT LEVEL) This indicates the [LINE OUT] (L and R channels) and [MONITOR OUT] output levels. Select the center ·Allows the CH ( , ) input selected with the [MONITOR CUE] and the output from the [LINE OUT] connector to be control mixed and monitored. MONITOR volume level control (MONITOR LEVEL) MONITOR BALANCE control (MONITOR BALANCE) This adjusts the balance between the [LINE OUT] source and source selected by the [MONITOR CUE] selector. MONITOR source selector (MONITOR CUE) Channels and can be selected as the output for headphones or monitor speakers regardless of the position of the faders. Note: The channel faders are designed for a long service life, but this can be shortened if they are used in a situation that requires rapid movement, such as during Hip-Hop transfer play. The controls may need to be replaced frequently if used this way. [. . . ] Is the master level control or another volume level control at the [MIN] position?Have any of the units been connected with the left and right channels reversed?Is there a fluorescent light or other electrical appliance or its power cord near any of the connecting cords?Has the turntable's grounding wire been disconnected? Remedial action Connect the power plug securely. [. . . ]