User manual PANASONIC SL1200GREG

[. . . ] Each day the discovery of a truly emotive experience from an unencountered sound awaits. Let us take you on your journey to rediscover music. (02) English Delivering the Ultimate Emotive Musical Experience to All At Technics we understand that the listening experience is not purely about technology but the magical and emotional relationship between people and music. We want people to experience music as it was originally intended and enable them to feel the emotional impact that enthuses and delights them. [. . . ] ρ Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp. ρ Return the tone arm to the arm rest and fix it with the arm clamp. 1 Free the tone arm from the arm rest and adjust horizontal balance by turning the balance weight. Hold the tone arm and turn the balance weight in the arrow direction to adjust the balance until the arm is approximately horizontal. ρ Take care not to Balance weight allow the stylus tip to touch the Hold here turntable or main to turn unit. 1 Turn the stylus pressure control until “0“ comes to the centre line of the rear of the tone arm. ρ Hold the balance weight still while doing this. Stylus pressure control Hold here to turn Balance weight Centre line Arm clamp Arm clamp Arm rest Cue lever Anti-skating control Note  Refer to the user's guide for your stylus for the appropriate stylus pressure. Balanced and the tone arm is parallel to the turntable. 18 (18) English Anti-skating 2 Turn the balance weight to adjust to the appropriate stylus pressure for the cartridge. ρ The stylus pressure control will turn together with the balance weight. ρ Turn until the centre line points to the appropriate stylus pressure. 1 Turn the anti-skating control to adjust it to the same value as the stylus pressure control. Getting started Balance weight Hold here to turn Turns together 1 0 Centre line Note  For stylus pressures 3 g and above, adjust anti-skating control to “3”. 2 3 19 English (19) Adjustment (continued) Tone arm height Make this adjustment only if the cartridge you are using makes it necessary. Preparation  Put a record on the turntable. 3 After arm height adjustment is finished, lock the tone arm by turning the arm lock knob. ρ Be sure to turn the arm lock knob to the end as shown in the figure below. You may need to apply some force to do so. Arm lock (Released) (Locked) 2 Adjust the height with the armheight control ring. Adjust the arm height until the tone arm becomes parallel to the record. When you don't know the cartridge  height (H) or when you don’t use the supplied head shell  Use the chart below as reference to find the appropriate position mark for the height of your cartridge. [. . . ] 5 kg (including a rubber sheet) Arm-height 0 – 6 mm adjustment range Stylus pressure 0 – 4 g (direct reading) adjustment range Head shell weight Approx. 6 g Applicable cartridge weight range (Without the auxiliary weight) 5. 7 g (including the head shell) (With the auxiliary weight) 10. (JIS C5521) 78 dB (IEC 98A weighted) Specifications are subject to change without notice. [. . . ]