User manual PANASONIC SL-90I

[. . . ] Play surface (shiny surface) Note: The "EB" indication shown on the packing case indicates United Kingdom. Handling precautions If you are taking the CD from a cold to a warm environment, moisture may form on the CD. Wipe this off with a soft, dry, lint-free cloth before using the CD. Do not write on the label side with a ballpoint pen or other writing instrument. Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids or any other solvent. [. . . ] Re-connect the power source and continue operation. HOLD Function This function causes the unit to ignore short, accidental "(" indication button presses. (The disc lid can still be opened and When the unit is in HOLD mode, pressing any button closed. ) causes the indication "(" to appear on the display. s HOLD HOLD HOLD 2 HOLD mode 2 VOLUME r The HOLD function prevents the following: Powering on the unit accidentally (which can cause the batteries to run down). Play being cut off unexpectedly in the middle of a selection. When the unit is powered off The "(" indication appears only when [1;] is pressed. To use the HOLD function Set [HOLD] to the HOLD position. The unit and wired remote control have HOLD functions, each of which works independently. Before operating the buttons Be sure to move [HOLD] to release the unit from the HOLD mode. Sequential Play Basic Play Track number in play OPR OFF 9 5 5 1; S-XBS A. SHOCK : 6 Elapsed playing time of each track 6 1 Operation VOLUME 654 4 3 RESUME RANDOM NORMAL HOLD Close the lid. Plug type: 3. 5 mm stereo OPEN 2 R L Follow steps 1­6. For your reference: In step 2, connect the wired remote control and the stereo earphones to the headphone jack [Ë]. (Plug in firmly. ) ")" indication Play stops automatically when all the tracks have been played. This indication appears for about 30 seconds if [1;] is pressed If the unit has been connected to the car audio system, adjust the volume level between 4 and 6 on the unit, then adjust the volume when no disc is loaded in the unit or if the disc is not properly selevel on the system. cured. "*" indication Button Press during play. Display/reference S-XBS A. SHOCK This indication appears for about 10 minutes when the cover is opened. (However, the indication does not appear when the unit is powered off. ) To pause play Press during play. 1; Auto power off function Press again to restart play. Total playing time Total number of S-XBS A. SHOCK tracks If the unit is left in stop or paused status for approximately 10 minutes, the unit powers itself off automatically in order to prevent the batteries from running down. (If no disc is loaded in the unit, it powers itself off in about 30 seconds. ) To stop play Stop mode OPR OFF Removing discs Press during stop mode. 1 To turn off the unit Off mode OPR OFF 2 3 During program play (page 4), these buttons are used to skip forward or back through the programmed sequence of tracks. Adjust the volume on the amplifier. Maintenance If the surfaces are dirty To clean this unit, wipe with a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth dipped in a soap-and-water solution or a weak detergent solution. Never use alcohol, paint thinner or benzine to clean this unit. Before using chemically treated cloth, read the instructions that came with the cloth carefully. Using the unit with a car audio system Items to be purchased For connection to the car audio system: Car stereo cassette adaptor (SH-CDM10A) Connect the car stereo cassette adaptor to the unit's headphone jack. (When doing this, keep the unit's VOLUME at a setting between 4 and 6. ) Maintaining the lens Open the lid and clean the lens as shown in the figure. Use a cotton swab to gently wipe off any finger-prints. Recommended product: Lens cleaner kit (SZZP1038C) Air blower for camera lens Lens Note! Sound quality changes when S-XBS, TRAIN or LIVE is selected, but volume is reduced by about half. You can connect speakers, active or otherwise, with an impedance of 1 k or less to the headphone jacks. Set the unit's volume between 4 and 6. OUT jack RESUME RANDOM NORMAL HOLD OUT For securing the unit and connecting the power supply: Car adaptor (SH-CDC9) Car mounting kit (SH-CDF7) Car mounting arms, Car insulator Note. Side panel of the unit It may not be possible to use the unit with some types of car stereo owing to restrictions imposed by the construction of the car stereo cassette adaptor. For further details, refer to the instructions of the part concerned. [. . . ] Do not mix different types or makes of batteries or old and new batteries. Remove the batteries if you do not intend to use the unit for a long time. Do not throw into fire, short-circuit, disassemble, or subject to excessive heat. Do not attempt to recharge dry cell batteries. [. . . ]