User manual PANASONIC SLMP70EG

[. . . ] Storage precautions Be sure to store CDs in their cases to protect them from dust, scratches, and warping. Do not place or store CDs in the following places Locations exposed to direct sunlight Humid or dusty locations Locations directly exposed to a heat vent or heating appliance In the glove compartment or on the rear deck of an automobile Handling precautions If you are taking the CD from a cold to a warm environment, moisture may form on the CD. Wipe this off with a soft, dry, lint-free cloth before using the CD. Do not write on the label side with a ballpoint pen or other writing instrument. [. . . ] (Plug in firmly. ) In step 5: The volume range is 0-25. (Press and hold to change the volume successively. ) The volume changes when pressed while the level is displayed. If any other display is shown, it changes to show the current level. (The volume returns to 10 when you disconnect the power source. ) Play stops automatically when all the tracks have been played. If the unit has been connected to the car audio system, set this unit's volume to 10, then adjust the volume level on the system. Resume function The player stores the track where you stopped play and if you press [1 ;] (main unit) or [/1] (remote control) play resumes from the beginning of the track. The resume function is canceled (play starts from the first track) if you open the lid when the unit is in stop mode. It is also usually canceled when you replace the CD while the unit is off. Operation Display/reference RANDOM VOL ALL1 M C SORRY LIVE S-XBS TRAIN Note! The resume function may work if you replace the CD while the unit is off. If you turned the unit off near the end of the track, play may resume from the beginning of the next track. The resume function works automatically and cannot be turned off. Press during play. To pause play Press during play. Press again to restart play. Total playing time OPR OFF To stop play Stop mode Total number of tracks RANDOM VOL ALL1 M C SORRY LIVE S-XBS TRAIN Removing discs Press [, OPR OFF] to stop play and disc rotation. Do not stop the disc by hand or try to remove it before it stops rotating. Turn off this unit and the other equipment before connection. Do not connect the cable to the PHONO jacks on the amplifier. Obtain the optional connecting cable if the other equipment comes with mini-phone jacks. Set the unit's volume to 10, then adjust the volume level on the other equipment. You can connect speakers, active or otherwise, with an impedance of 1 k or less to the headphone jack. Maintenance If the surfaces are dirty To clean this unit, wipe with a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth dipped in a soap-and-water solution or a weak detergent solution. Never use alcohol, paint thinner or benzine to clean this unit. Before using chemically treated cloth, read the instructions that came with the cloth carefully. Using the unit with a car audio system Items to be purchased For connection to the car audio system: Car stereo cassette adaptor (SH-CDM10A) Connect the car stereo cassette adaptor to the unit's headphone jack. (When doing this, set this unit's volume to 10. ) Maintaining the lens For securing the unit and connecting the power Open the lid and clean the lens as shown in the figure. Use a cotton swab to gently wipe off any finger-prints. supply: Recommended product: Lens cleaner kit (SZZP1038C) Car adaptor (SH-CDC9) Car mounting kit (SH-CDF20) Note when using the car mounting kit (SH-CDF20) 1Remove the screw from the bracket at the rear of the car mounting base. [. . . ] Remove the batteries if you do not intend to use the unit for a long time. Do not throw into fire, short-circuit, disassemble, or subject to excessive heat. Do not attempt to recharge dry cell batteries. Do not allow metal objects to touch the battery terminals as this may cause short-circuiting which is dangerous. [. . . ]